Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

F UEL IN JECTI ON AND GOVERNOR SYSTEMS 145 .:IfiJi'r - Spill pipe 3A. On IGM and IGMIO models -Unscrew the fuel in- .----" jcction line retaining nut (Figure 16) and disconnect the fuel line from the pump. 7 NOTE On 2GM, 2GM20, 3GM, 3GM30, 3HM and 3HM35 engines, the cylinder nearest thefly- wheel is the number one cylinder. 38. On 20M, 2GM20, 3GM, 3GM30, 3HM and3HM35 models-Unscrew the fuel injection line retaining nut (Figu re 17) for the number one cylinder fuel injection line, then disconnect the fuel line from the pump. 4. Install a spill pipe on the pump in place of the high-pressure fuel line (Fig ure 18). NOTE Jfa spiff pipe is not available or cannot he fabricated.

observe fuet flow in the open nipple. 5. Place the speed control lever at the mid-throttle posi- tion. NOTE Do not use the starter motor when rotating the crankshaft. NOTE Always rotate the crankshaft in the normal running direction (clockwise at the crank- shaft pulley); otherwise the water pump im- peller may be damaged. Adjust Fucl lnjcction Timing 1. Make sure there is no air in the fuel system. If neces- sary, bleed the fuel system as described in the previous section. 6. Rotate the crankshaft with the crankshaft pulley retain- ing nut until the IT mark on the flywheel appears. 2.

If there is no flywheel observation hole in the clutch cover (Figure 14), remove the starter motor so the timing marks on the flywheel (Fi gure 15) are visible. NOTE The piston must be 011 its comp ression stroke. If fuel does not appear in the spill pipe , the piston may 1I0the on the compres-