Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

146 C HAPTER SEVEN sian stroke. Rotate the crankshaft one full turn. 7. Slowly rotate the crankshaft while observing the fuel in the fuel nipple on the injection pump and the timing marks on the flywheel. 8. When fuel appears in the spill pipe, the injection tim- ing mark on the flywheel (A. Fig ur e 19) should align with the reference pointer (B) on the clutch cover. If viewing marks through the starter hole, the injection timing mark on the flywheel (A, Fig ure 20) should align with the ref- erence mark (B) on the clutch cover. NOTE There are two timing marks [or each cylin- der 011 the flywheel: a mark for top dead center (TDC) and the injection timing mark.

The TDC mark is identified by a T next to the mark. Near the TDC mark is another mark, the injection liming mark, which has no identifying letters or numbers. The injection timing mark is to the right of the TDC mark when viewing the mark through the starter hole, or to the leli of the TDC mark when viewing the mark through the clutch cover hole. 12, Install the shims and injection pump, then recheck in- jection timing. 13. On 2GM, 2GM 2D, 3GM, 3GM3 D, 3HM and 3HM35 models-s-Check fuel injection timing for the remaining cylinders. Use the injection timing mark adjacent to the 2T or 3T marks for the cylinder being checked.

If injec- tion timing is incorrect for the number two or three cylin- ders, have a Yanmar dealership or diesel fuel injection shop inspect the injection pump. 9. If the injection timing is not correct, remove the fuel injection pump as described in this chapter. FUEL [ VJECT OR I D. Measure the shim pack located between the pump and engine mounting surface ( Figure 21). Each cylinder is equipped with a fuel injector (f igure 22). Refer to Fuel Inj ector in the Fuel Injection Fundamentals section of this chapter for information re- garding fuel injector operation. Maintaining optimum fuel injector perfonnanec is pri- marily dependent on using clean fuel.

Din or debris in the fuel is the predominant cause of poor injector perfor- mance . The injector is also subject to the heat and byprod- ucts of combu stion. The fuel injector nozzle is protected from combustion heat by a heat shield. However, heat and liA . Injection timing retarded -If injection timing is re- tarded, decrease the shim thickness to advance injection timing. Decreasing shim thickness D.I mm will advance injection timing one degree. 11 B. Injection timing advanced- If injection timing is ad- vanced, increase the shim thickness to retard injection timing . Increasing shim thickness 0.1 mm will retard in- jection timing one degree .