Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

152 CHAPTER SEVEN seal properl y if reused. Always install new washers when reconnecting a fitting. The fuel lines are secured with brackets to prevent leaks due to eng ine vibration. Periodically check that fuel lines are properly secured with brackets. The high-pressure fuel injection lines are held by a rubber pad in the bracket (Figure 41). Replace any rubber pads that are missing or no longer holding the line securely. GOVER:\OR SYSTE:\I Ope rat ion The governor components are in the timing gearcasc (Flgure 42, typical). The purpose of the governor system is to maintain engine speed regardless of the load im- posed.

The mechanical governor system utilizes centrifuga l force 10 monitor and adjust engine speed. Refer to Fi2u rc 43. Figure 44 and Figure 45. A set of flyweights are mountcd on the crankshaft. When engine speed increases, the flyweights are thrown out. When engine speed de- creases, the flyweights recede. Trapped between the fly- weights is a flanged sleeve that moves in and out with the flyweights, pushing against a forked governor arm. The forked governor arm transfers motion to the governor le- ver, which is connected to the fuel injection pump fuel control rack.

The governor spring tension forces the speed control lever against the governor lever, which forces the injection pump speed control rack to the full open throttle position. When load on the engine increases and engine speed decreases, the governor sleeve is withdrawn, which through the linkage moves the speed control rack to in- crease fuel injection. When load on the engine decreases and engine speed increases. the governor sleeve extends, which moves the linkage to overcome governor spring tension. The linkage moves the speed control rack and de- creases fuel injection. The governor controls engine speed in an operating range between idle speed and maximum governed speed.

Maximum governed speed is critical as it sets the upper limit of engine operation. Exceeding the maximum gov- erned speed can cause overspceding, which may result in engine failure. A fuel limiter screw sets maximum injection pump fuel delivery. When the governor senses a decrease in engine speed, the fuel control rack moves to the full fuel position. The factory-adjusted fucllimiter screw stops the governor linkage at a point that provides maximum, but not exces- sive, fuel delivery to the engine.