FUEL INJECTION AND GOVERNOR SYSTEMS lSI Fuel transfer pump u Camshaft Ove rhaul 1 Internal parts for the fuel transfer pump are not avail- able. Replace a defective pump; do not attempt to over- haul it. FUEL LINES The fuel system utilizes both rubber and steel lines. When replacing fuel lines, use only lines recommended by the manufacturer or a diesel engine shop. Purchase the formed steel fuel lines from a Yanmar dealership. If nee- essary, a diesel fuel injection shop can fabricate fuel lines. All lines must be secured by brackets to prevent fractures or splitting due to vibration.
Inspection Periodically inspect the fuel lines for leaks and damage, such as dented or bent steel lines, or cut or abraded rubber lines. Leaks may be due to loose fittings or damage. Tighten loose fittings and recheck the leak after operating the engine. Do not overtighten a fitting to try to stop a leak; overtightening may damage the fitting threads or the fuel line scaling surfaces. If tightening does not stop the leak, disassemble the fuel line and inspect the line and seat to determine the cause of the leak. If sealing surfaces are damaged, replace the fuel line and, if necessary, the fuel fitting or component. 2. Disconnect the fuel lines (A, Figure 39) from the fuel transfer pump. 3.
Remove the fuel pump retaining bolts (8, Figure 39), and then remove the pump. 4. Clean any gasket material from the engine and the fuel pump. 5. Reverse the removal procedure 10 install the fuel trans- fer pump. Bleed the fuel injection system as described in this chapter. NOTE A {ways operate the engine and check [or leaks after reconnecting thefuei Iines. NOTE The transfer pump output port on 1 GM and lGMIO engines is on the left side with the pump mounted on the engine. On all other Fuel lines with banjo fittings (A, Figure 40) are equipped with copper sealing washers (B) on both sides of the fitting.
Copper washers harden with age and will not engines, the output port is on the right sid e.