Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

150 C HAPTER SEVEN ernor linkage/or easier pump removal and installation. 6. Lift the injection pump out of the engine while care- fully disengaging the governor linkage from the pump. 7. Remove the timing shims (Figure 34) and set them aside for reinstallation. 8. To reinstall the injection pump, reverse the removal procedure. Make sure to reinstall the timing shims and en- gage the control rack pin (Fig ure 35) with the governor lever fork. Tighten the pump retaining nuts to 25 Nom (18 ft.-lb.). Bleed the fuel injection system as previously de- scribed. Run the engine and check for leaks. FUE L TRA!\ 'SFE R PUMP 2. Operate the engine starter.

If the fuel transfer pump is operating properly, fuel will flow from the air bleed screw hole. The engine is equipped with a fuel transfer pump (A, Figure 36) to move fuel from the fuel tank to the fuel filter and fuel injection pump. A cam lobe on the engine cam- shaft operates the pump lever (Fig ure 37), which moves the fuel pump diaphragm to pump the fuel. Fuel pump pressure is approximately 9.7 kPa (1.4 psi). 3. If fuel does not flow from the air bleed screw hole, dis- connect the output fuel line (B, Fi gur e 36) from the fuel pump. NOTE Be prepared to catch fuel expelledfro m the pump.

The transfer pump outpu t port on lGM and IGM IOen- gines is on the left side with the pump mounted on the en- gme. On all other engines, the output port is on the right side. 4. Operate the engine starter. If fuel docs not flow from the fuel pump, replace the pump. Fuel Pump Testing WARNING Always have a fire extinguisher, rated for file! and electricalfires, on hand when ser- vicing any part ofthefue! system. Clean up any spilled fuel as soon as possible. Removal and Installation I. Close the fuel tank valve. NOTE Accountfor the sealing washers on thefue! hose ends. I. Loosen the air bleed screw (Fig ure 38) on the fuel fil- ter.