Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

FUEL INJECTION AND GOVERNOR SYSTEMS 149 FUEL INJ ECTION PUMP 7 The fuel in jec tion pump is built to precise specifications and is easily damaged by contamination from dirt or de- bris . Due to the close tolerances in the pump and the spe- cial tools and equipment required for overhaul and testing, have a Yanmar dealership or diesel fuel injection shop perform any unnecessary service . Removal and Installation WARNING Serious fire hazards always exist around diesel fuel. Do not allow any smoking in ar- eas wherefuel is present. Always have afire extinguisher. rated for fuel and electrical fires, on hand when servicing any part of the fuel system. I. Close the fuel shutoff valve. 2.

Thoroug hly clean the fuel injection pump and the area around the pump of all debris. NOTE Plug or cap allfuel openings to prevent the entrance of debris. 19. Connect the high-pressure fuel line to the injector. 20. Install the retainer plate so the side with bumps (Fig- ure 32) is down and contacts the injector. 3. Detach the fuel supply line from the fuel injection pump (A, Figure 33). 4. Unscrew the fuel line retaining brackets. Remove the fuel injection line(s) between the fuel injection pump and fuel injector(s) (8, Figure 33). 5. Remove the injection pump retaining nuts (C, Figure 33). 21. Install the retaining nuts. Tighten the nuts evenly to 20 Nem (14.5 fl.-lb.). 22.

Connect the fuel return line. 23. Reattach fuel line retaining brackets. NOTE Removing the oil fill cap on lGM and IGMI0 models provides access to the gov- 24. Bleed the fuel injection system as described in this chapter. Run the engine and check for leaks.