Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

148 CHAPTER SEVEN 7. Extract the precombustion chamber and copper gas- kets (Figure 28). Note that there is a copper gasket (Fig- ure 29) above and below the chamber; make sure to remove the bottom gasket after remov ing the chamber. 8. On models so equipped, remove and discard the O-ring on the fuel injector (Fig ure 23). 9. Plug the opening in the cylinder head to prevent the en- try of dirt or debris. 10. Refer to the following section for injector testing and cleaning information. 11. Inspect the precombustion chamber. If damaged, dis- card the chamber. Clean the heat shield. 12. Discard the gaskets and install new gaskets.

Thor- oughly remove any gasket residue in the top of the heat shield. , 15. Install the upper copper gasket onto the precombustion chamber. 13. Install the bottom copper gasket in the injector bore in the cylinder head. 14, Install the precombustion chamber with the holes to- ward the cylinder head. Align the pin on the side of the precombustion chamber (Fig ure 30) with the groove in the injector bore (Figure 31). 16. Install the heat shield and gasket. The open side of the heat shield must be down. 17. Install the O-ring onto the fuel injector (F igur e 29). 18, Install the fuel injector into the injector bore in the cylinder head (Fig ur e 26).