Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

COOLING SYSTEM 165 HEAT EXCHANGER Cooling tube Seawater outlet Baffle plate Seawater inlet Gasket , Side cover Freshwater inlet (from cylinder head) Freshwater inlet (to freshwater reservoir) Side cover Cooling pipe cover coolant travels to the heat exchanger, where the heat ab- sorbed from engine operation passes through the parallel copper tubes to the water in the seawater system. Engine cooling is thus accomplished without seawater entering the engine. This eliminates the corrosion, deposit buildup and debris accumulation that occurs in a standard cooling system, resulting in longer engine life-espe- cially if the boat is used in saltwater.

Like an automotive cooling system, the freshwater sec- tion is pressurized at 13 psi. This raises the boiling point of the coolant to permit higher operating temperatures for increased engine efficiency. A thermostat controls coolant circulation. When the thermostat closes, it prevents coolant from entering the heat exchanger, rerouting it back to the engine circulating pump. Once the thermostat opens, it closes off the passage to the circulating pump and sends the coolant through the heat exchanger before returning it to the engine pump. This provides quick engine warm-up and maintains a con- stant operating temperature.

THERMOSTAT The thermostat blocks coolant flow to the exhaust man- ifold (standard cooling) or heat exchanger (closed cool- ing) when the engine is cold. As the engine warms, the thermostat gradually opens, allowing coolant to circulate through the system. CAUTION Do not operate the engine without a thermo- stat. This can lead to serious engine dam- age. Thermostats are rated according to their opening tem- perature. The opening temperature value is stamped on the thermostat. The thermostat should start to open at the temperature stamped on the thermostat and should be fully open at 25° F (14° C) above that temperature.

Check the thermostat rating after removing the thermostat and compare it to the specifications in Table 2.