Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

166 CHAPTER EIGHT R emev al/l nst allation Seawater cooling system.f The thermostat on 1GM and IGM I0 engines is located in the cylinder head (Flgure 2). The thermostat on two- and three-cylinder engines is located in the thermostat housing (Fi gure 3 and Flg ure 4). 311M and 3HM35 en- gines arc equipped with two thermostats (Fig ure 4). 1. Drain the seawater from the engine as desc ribed in Chapter Four . 2. Loosen the hose clamps and disconnect the hoses from the thermostat cover (Figure 8). DOWN 3. Remove the thermostat cover retaining bolts and washers. R emove the c over and the gasket. Discard the gasket. 4. Remove the thermostat (Figure 9). On 3HM and 3 11 M35 engines, remove beth. 5.

Test the thermostats as described in this chapter. Freshwater cooling systems 6. Clean the thermostats cover and housing or cylinder head mating surfaces of all gasket residue. I. Drain the coolant from the engine as described in Chap ter Four. 2. Loosen the hose clamp (Ffgure II ) securing the cool- 7. Install the thermostat in the housing or cylinder head with its thermostatic element facing the engine. The ther- mostat flange must fit into the housing recess. anthosclothethermostateove~ 3. Remove the thermostat cove r retaining bolts and 8. Coat both sides ofa new gasket with sealant and insta ll the gasket onto the thermostat cover. washe rs( F i g u ~ II ).

Remove the cove r and the hose. Dis- card the gasket. 4. Remove the thermostat (Figure 12). 5. Test the thermostat as described in this chapter. 6. Clean the thermostat c ove r and housing mating sur- faces of all gasket residue. 7. Install the thermostat in the housing with its thermo- static element facing the housing. The thermostat flange must fit into the housing recess. 8. Coat both sides of a new gas ket with sea lant and install the gasket onto the thermostat cover. 9. Install the cove r. Note that the inlet and outlet nipples arc stepped. Install the cove r so the outermost nipple faces down, as shown in Ftgur c 10. Tighten the bolts securely. 10.

Reconnect the hoses to the thermostat cover and tighten the clamps securely. 11. Operate the engine and check for leaks. Operate the engine until it reaches normal operating temperature. Im- mediately shut down the engine if overheating occurs and correct the problem.