Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

167 COOLING SYSTEM Hose clamp Cover bolts --- --- ;;;';;';;;;';;'~-=---:.. -- -- -- Testing (Out of Engine) 1. Pour some tap water (not distilled water or coolant) into a container that can be heated. Submerge the thermo- stat in the water and suspend a thermometer as shown in Figure 13. NOTE Suspend the thermostat with wire so it does not contact the pan. 2. Heat the water until the thermostat starts to open. Check the water temperature on the thermometer. It should be approximately the same as the temperature value stamped on the thermostat. If the thermostat has not started to open at this temperature, replace it. 3.

Heat the water another 25° F (14° C) above the temper- ature value stamped on thermostat. The thermostat should now be fully open. If it is not, replace it. 4. Allow the water to cool to 10° F (6° C) under the ther- mostat's rated opening temperature. If the thermostat valve is not fully closed at this temperature, replace it. 5. Remove the thermostat from the water and let it cool to room temperature. Make sure the valve seals tightly by holding the thermostat up to a light. If light is visible around the edge of the valve, replace the thermostat. Testing (In Engine) 9. Install the cover while connecting it to the coolant hose. Tighten the bolts securely.

Thermostat operation can be tested without removing it from the engine or reservoir. This procedure requires the use of two thermomelt sticks (Figure 14) available from marine supply or automotive parts stores. A thermomelt stick looks like a carpenter's pencil and is made of a chemically impregnated wax material that melts at a spe- cific temperature. 10. Tighten the hose clamp securely. 11. Operate the engine and check for leaks. Operate the engine until it reaches normal operating temperature. Im- mediately shut down the engine if overheating occurs and correct the problem.