Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

168 CHAPTER EIGHT Thi s technique can be u sed to che ck the rmostat openin g by marking the th cnno stat housing with two thermomelt sticks: one with a temperature lower than the thermostat opening temperature, and one with a temperature higher than the full open position. When the coolant or water reaches the first temperature, the mark made by that stick will melt. The mark made by the second stick will not melt until the coo lant or water increases to that temperature. WARNING Do not remove the pressure jill cap from a fresh ..... ater (closed) coolingsystem while the engine is warm. Coolant may blowout ofthe heat exchanger and cause serious personal injury. Overheated Engine 1.

Relieve the freshwater cooling system pressure by carefully removing the pressure fill cap from the heat exchanger. Sec Figure 15. typical. 2. Rub a 180 0 F (82 0 C) the rmo melt stick on the th ermo - stat cover. 3. Start the engine and run at a fast idle. 4. Ifn o coo lant flows into the heat exchanger by the time the mark starts to melt. either the thermostat is stuck closed or the water pump is failing. Remove the thermo- stat and test it as desc ribed in this chapter. I ft he results are satisfactory, replace the water pump. system is maintained; however, it is a good idea to change all hoses every two years. Always replace a cooling sys- tem hose with the same type as removed.

Pleated rubber hoses do not have the same strength as reinforced molded hoses. Check the hose clamp cond ition and install new marine-grade clamps with a new hose, if necessary. Partially drain the cooling system when replac ing upper hoses. Completely drain it when replac ing lower hoses. Slow Engtne Warm -Up I. Relieve the freshwater cooling system pressure by carefully removin g the pressure fill cap from the heat exchanger. Sec Ftgure IS, typical. 2. Rub the 160 0 F (71 0 C) thermomelt stick on the ther- mostat cover. 3. Start the engine and run at a fast idle. 4. If coolant or water flows into the heat exchanger be- fore the mark starts to melt.

the thermostat is stuck open and should be replaced. I. Loosen the clamp at each end of the hose to be re- moved. Grasp the hose and twist it off the fitting with a pulling motion. 2. If the hose is corroded 10 the fitting and will not twist free, remove the clamp and insert a small screwdriver or pick tool between the hose and the fitting. Work the tool around the fitting, then remove the hose. 3. Clean any rust or corrosion from the fining with a wire brush. 4. Wipe the inside diameter of the new hose with liquid detergent and install the hose ends on the fittings with a twisti ng motion. 5. Position the new clamps a tleas t 1/4 in. (6.4 mm) from the end of the hose.

Make sure to position the clamp screw for easy access with a screwdriver or nut driver. Tighten each clamp snugly. IIUSE REPLACEMENT Replace any hoses that are cracked, brittle, or very soft and spongy. If a hose is in doubtful condition, replace it to be on the safe side. Hoses in some installations are ex- tremely difficult to change; attention to hose condition can prevent a failure while off-shore. Hose manufacturers generally rate coo ling system hose life at two years. How long the hoses will last depends a great deal on how much the boat is used and how well the