Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

COOLING SYSTEM 169 DRIVE BELT ROUTING Engine circulation pump Alternat or Alternator Seawater pump SEAWATER COOLING SYSTEM Seawater pump 8 CLOSED COOLING SYSTEM 6. Refill the cooling system . Start the engine and check for leaks. Recheck the clamps for tightness after operating the engine for a few hours. also overstress the bearings, resulting in premature fail- ure. Only install heavy-duty belts. Do not install light-duty belts, such as those designed for automobile use. R ef er to Figure 16 for drive belt routing diagrams. DRI VE BELTS Inspect all drive belts at regular intervals to make sure they are in good condition and are properly tensioned.

Re- place worn, frayed, cracked or glazed belts immediately. The components to which they direct power are essent ial to the safe and reliable operation of the boat. If correct ad- justment is maintained on each belt, all will usually give Belt Adjustment R ef er to Chapter Three for belt adjustment procedures. Belt Replacement the same service life. For this reason, and because of the cost involved in replacing an inner belt (requiring the re- moval of the outer belt), it is a good idea to replace all belts as a set.

The added expense is small compared to the cost of replacing the belts individually and eliminates the possibili ty of a breakdown on the water, which could cost far more in time and money. Alternator drive belt replacem ent Replace the alternator drive belt as follows: I. Loosen the alternator bracket and pivot bolts (Figure 17, typical). 2. Move the alternator toward the engine and slip the belt off the crankshaft and alternator pulleys, and if equipped with freshwater cooling, the circu lating water pump pul- ley. 3. Install a new belt over the pulleys. 4. Move the alternator away from the engine and adjust the belt tension as described in Chapter Three.

Drive belts should be properly tensioned at all times. If loose, the belts will not permit the driven components to operate at maximum efficiency. The belts will also wear rapidly because of the increased friction caused by slip- page. Belts that are too tight will be overstressed and prone to premature failure. An excessively tight belt will