170 CIIAPTE R EIG IIT -{. ' . -. ' ~ . , ito ··'l .J.. Bolts L- +-- -~ D Sea water pum p drive b el t replacement (except I GJI and IG.UI Oengines) Replace the seawater drive belt as follows: I. Loosen the alternator bracket and pivot bolts (Figure 17, typica l). 2. Move the alternator toward the engine and slip the belt off the crankshaft and alternator pulleys, and if equipped with freshwater cooling, the circulating water pump pul- Icy. 3. Loosen the seawater pump bracket and pivot bolts (Fi J:: ure 18, typical), 4. Move the seawater pump toward the engine and slip the belt off the crank shaft and pump pulleys. 5. Install a new belt over the pulleys. 6.
Move the seawater pump away from the engine and adjust the belt tension as described in Chapter Three. 7. Install the alternator drive bell onto the crankshaft and alternator pulleys. and if equipped with freshwater cool- ing. the circulating water pump pulley. 8. Move the alternator away from the engine and ad ju st the belt tension as described in Chapter Three. tcr out of the discharge port as the impeller vanes flex inward . as shown in Fi gur e 20. The impeller only operates in a counterclockwise rota- tion (viewed from cover side of pump) and remains in a flexed (compressed) position at all times. Over time, this causes the impeller to take a set in one direction .
Turning an impeller over and attempting to tum it against its natu- ral set will cause premature impeller failure and engine damage from overheat ing. Replace the impeller every time the water pump is dis- assemb led. The impeller must only be reused if there is no other option. If the impeller must be reused . reinstall the impeller in its origina l position. SEA WATE R P UMP All engines covered in this manual use a seawater pump (Ftgure 19. typical). The seawater pump on IGM and IGMIO engines is driven by the end of the oil pump drives haft. All other engines use a belt-driven seawater pump. A rubber impeller inside the pump moves water through the pump.
The pump draws water into the intake port as the impeller vanes flex outward. and it pumps wa- Overheating and extensive engine dama ge can result from a faulty water pump. Therefore, it is highly recom- mended that the water pump impeller, seals and gaskets be inspected after every 1,500 hours of operation as a pre- ventive maintenance meas ure. Individual operating con- ditions may dictate that the pump will require service more often.