Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

COOL ING SYSTEM 171 If the engine was run without an adequate supply ofwa- ter to the pump, disassemble the pump and replace the im- peller and any other damaged parts. Wat er Pump Ope rating Mtsrakes Do not run an engine immediately after pulling a boat out of water. This is an extremely risky operation, but here is why some people often seem to get away with it. If an engine has just been pulled out of the water, there is resid- ual water in the cooling system and eng ine that drains back down to the water pump.

This water will lubricate the water pump for a short period of time (perhaps a cou- ple of minutes), but the pump will be damaged as soon as the heat from operation evaporates all water in the system. Do not operate the pump without an adequate water sup- ply. ....-....., Do not stan an engine with the boat out of the water, but without a water supply, to make sure the motor will run 1. ..1 when the boat is launched. This is an unacceptable and very dangerous procedure. If an engine has been sitting for any length of time, the water pump is completely dry and the impeller will sustain immediate damage if the en- gine is operated without an adequate water supp ly.

Water must be supplied to the pump through the boat's water in- take or supplied under pressure from a flushing device. Impeller direction 8 CAUTION Supply the pump with an adequate water supply anytime the engine is running. Seawater Pump Precaut ions The seawater pump suffers from many misconceptions about its ability to withstand operation without water be- ing supplied to it. All impellers are made of some varia- tion of rubbe r. The water pump housing is made of metal. If a piece of rubber is rubbed across a piece of metal, there is severe friction and considerable heat buildup.

However, if the metal is flooded with water while the rubber is moved across it; the friction would be greatly reduced and the heat buildup non-existent. Do not crank the engine for an extended period, such as during troub leshooting. This is detrimental to a water pump that is completely dry. Consi der attaching a flush- ing device before initially cranking an engine with a dry wate r pump. This will ensure the pump is wet and will not be damaged. It will not be necessary to keep the water supply flowing during all cranking periods; it is just im- portant to keep the pump wet during extended cranking. Basically,the water pump works the same way.

The wa- ter passing through the pump lubricates and cools the im- peller and pump housing. Without the water, the pump will overheat and the impeller will begin to melt almost instantaneously. Of course, this can be secondary to the potential damage to the engine from overheating. Removal/Installation I GM and I GMIO I. I fth e boat is in water, make sure the seacock is closed. 2. Drain the seawater from the engine as described in Chapter Four. 3. Loosen the hose clamps, then detach the water hoses from the seawater pump. 4. Remove the pump retaining screws (Figure 21) and re- move the pump.

Remove and discard the gasket, if so Once the impeller sustains any damage, its pumping ability is greatly diminished because the impeller can no longer seal adequately. The impeller must seal on its edges, as well as the blade tips.