172 CHAPTER EIGHT A equipped. Some engines are equipped with an O-ring that seals between the pump and engine. 3HM and 3HM35 5. Reverse the removal steps to install the pump. Refer to Table 1 for the tightening torque of the pump retaining screws. 1. Ifthe boat is in water, make sure the seacock is closed. 2. Drain the seawater from the engine as described in Chapter Four. 3. Loosen the hose clamps, then detach the water hoses from the seawater pump. 4. Loosen the seawater pump bracket and pivot bolts. 5. Move the seawater pump toward the engine and slip the drive belt off the pump pulley. 6.
Unscrew the pulley retaining nut (B, Figure 23), then remove the pulley for access to the pump mounting bolts. 7. Remove the mounting bolts (C, Figure 23), then sepa- rate the pump from the mounting bracket. 8. Reverse the removal steps to install the pump. Refer to Table 1 for the tightening torque of the pump mounting bolts. Adjust the belt tension as described in Chapter Three. 2GM, 2GM20, 3GM and 3GM30 2. Drain the seawater from the engine as described in Chapter Four. 1. Ifthe boat is in water, make sure the seacock is closed. 3. Loosen the hose clamps, then detach the water hoses from the seawater pump. 4. Loosen the seawater pump bracket and pivot bolts (A, Figure 22). 5.
Move the seawater pump toward the engine and slip the drive belt off the pump pulley. 6. Remove the pump mounting bolts (B, Figure 22), then separate the pump from the mounting bracket. DisassemblylReassembly 7. Reverse the removal steps to install the pump. Refer to Table 1 for the tightening torque of the pump mounting bolts. Adjust the belt tension as described in Chapter Three. IGM and IGMIO 1. Remove the three screws securing the pump cover to the body (1, Figure 24).