COOLING SYSTEM 173 SEAWATER PUMP (1GM AND 1GM10 MODELS) 10 11 ~ I I 12 (J 1. Screw 2. Cover 3. Gasket 4. Impeller 5. Cam 6. Cam retaining screw 7. Pump body 8. Q-ring 9. Seal 10. Seal 11. Bearing 12. Shaft 13. Snap ring 14. Bearing 15. Snap ring 16. Bolt 17. Washer 2. Remove the cover (2, Figure 24) and gasket (3). Dis- card the gasket. 3. Extract the impeller (4, Figure 24) from the pump body. 4. Rotate the pump shaft to check the bearings for rough- ness, excessive wear or other damage. Do not remove the shaft assembly unless replacement is necessary. 5. Unscrew the cam retaining screw (6, Figure 24), then remove the cam (5). 6.
Remove the snap ring (15, Figure 24) at the rear ofthe pump body. 7. Lightly tap the impeller shaft toward the rear of the pump to remove the impeller shaft and bearing assembly. 10. Clean all metal components with solvent, then dry them with compressed air. 11. Thoroughly clean all gasket material from all mating surfaces. 12. Inspect the pump shaft (12, Figure 24) for grooves in the seal contact area. 13. Inspect the impeller (4, Figure 24) for cracked blades or excessive wear at the tips ofthe blades. Replace the im- peller if any defects are observed. 14. Inspect the pump body and cover for grooves or other damage.
A damaged or excessively worn body or cover will reduce pump efficiency and may damage a new im- peller. 15. Install the shaft seal (9, Figure 24) so the lip is toward the impeller side of the pump body. 16. Install the oil seal (10, Figure 24) so the lip is toward the bearing side of the pump body. 17. If removed, install the snap ring (13, Figure 24) into the groove in the impeller shaft. 18. Press the shaft bearings onto the pump shaft until they seat fully against the snap ring. Press only on the bearing inner races. 19. Install the shaft and bearing assembly into the body. Install the snap ring (15, Figure 24).
NOTE When removing bearings, note the snap ring located between the bearings. 8. Press the bearings (11 and 14, Figure 24) from the pump shaft (12) using a universal press plate and arbor press. Force each bearing away from the locating snap ring (13, Figure 24). 9. Extract or push out the seals (9 and 10, Figure 24).