COOLING SYSTEM 175 SEAWATER PUMP (2GM, 2GM20, 3GM AND 3GM30 MODELS) 19 22 10 ~15 »~n~ ~ \ ~~t( 1 ~: ::,;;, ~~\J~\ 4. Spacer 13. Cam retaining screw 14. Elbow 15. Elbow 16. Cam 17. Impeller 18. Gasket 19. Cover 20. Screw 21. Bracket 22. Lockwasher 23. Bolt \ 7 8 5. Snap ring 6. Bearings 5 7. Spacer 8. Cover 9. Shaft 10. Seal ring 11. Seal 12. Pump body 3 2. Remove the cover (18, Figure 28) and gasket (17). Discard the gasket. 3. Extract the impeller (16, Figure 28) from the pump body and remove the drive key (8). 4. Rotate the pump shaft to check the bearings for rough- ness, excessive wear or other damage. Do not remove the shaft assembly unless replacement is necessary. 5.
Remove the snap ring (4, Figure 28). 6. Lightly tap the impeller shaft (7, Figure 28) toward the front of the pump to remove the impeller shaft and bearing assembly. 7. Unscrew the cam retaining screw (14, Figure 28), then remove the cam (15). NOTE When removing bearings, note the snap ring located between the bearings.