176 CHAPTER EIGHT SEAWATER PUMP (3HM AND 3HM35 MODELS) 3 7 8 5 6 1. Nut 2. Washer 3. Pulley 4. Snap ring 5. Bearings 6. Snap ring 7. Shaft 8. Key 9. Cover 10. Washer 11. Seal 12. Pump body 13. Fitting 14. Cam retaining screw 15. Cam 16. Impeller 17. Gasket 18. Cover 19. Screw 8. Press the bearings from the pump shaft using a univer- sal press plate and arbor press. Force each bearing away from the locating snap ring (6, Figure 28). 9. Extract or push out the seal (11, Figure 28). 10. Clean all metal components solvent, then dry them with compressed air. 11. Thoroughly clean all gasket material from all mating surfaces. 12. Inspect the pump shaft for grooves in the seal contact area. 13.
Inspect the impeller for cracked blades or excessive wear at the tips of the blades. Replace the impeller if any defects are observed. 14. Inspect the pump body and cover for grooves or other damage. A damaged or excessively worn body or cover will reduce pump efficiency and may damage a new im- peller. 15. Install the shaft seal (11, Figure 28) so the lip is to- ward the impeller side of the pump body. 16. If removed, install the snap ring (6, Figure 28) into the groove in the impeller shaft. 17. Press the shaft bearings onto the pump shaft until fully seated against the snap ring. Press only on the bear- ing inner races. 18.
Install the bearing cover (9, Figure 28) with the con- cave side toward the bearing. 19. Install the washer (10, Figure 28) onto the shaft. 20. Install the shaft assembly into the pump body. Install the snap ring (4, Figure 28). 21. Install the slotted washers (2, Figure 28), pulley (3) and nut (1), then tighten the nut. 22. Install the impeller drive key (8, Figure 28) in the slot in the impeller shaft. NOTE Replace the pump impeller anytime it is re- movedfrom the pump. If the original impel- ler must be reused, be sure to install it in the same rotational direction as originally in- stalled. 23. Lightly lubricate the tips and sides of the impeller.
In- stall the impeller into the pump body by rotating the im-