Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

COOLING SYSTEM 179 CLOSED COOLING SYSTEM DIAGRAM Pressure fill cap Remote tank ~;;;;;;;;;~~~~5~S~::----[: Heat exchanger By-pass Freshwater pump Thermostat Mixing elbow Cylinder head Seawater line Cylinder block Seacock Freshwater line ~ Seawater 10. Ifno signs ofleakage can be found in Step 8 or Step 9, yet the coolant level continues to require frequent topping off, there is probably an internal leak. This could be caused by a blown head gasket, loose cylinder head, or a cracked or porous head or block. If extremely dirty or corroded, flush out the remaining deposits with a pressure flushing device.

Refer to the cooling system flow diagram (Figure 35) and follow the manufacturer's instructions regarding the connection of the pressure flushing device and procedure to be fol- lowed. Cleaning Cleaning the Seawater Section of the Heat Exchanger Flush and clean the freshwater section every other sea- son or periodically as needed. Use any high-quality auto- motive cooling system cleaning solution to remove scale, rust, mineral deposits or other contamination. Use the cleaning solution according to the manufacturer's direc- tions. Contaminants and minerals collect inside the copper tubes in the seawater section of the heat exchanger during engine operation.

Such foreign material reduces the abil- ity of the heat exchanger to operate efficiently and, if not removed periodically, will eventually lead to engine over-