ELECTRICAL SYSTEM 185 making or breaking any connection. Poor connections are a common cause of electrical arcs that cause explosions. Care and Inspection The following battery maintenance information applies to unsealed, wet-cell batteries. Although some ofthe pro- cedures also apply to other types of batteries, consult the battery manufacturer for specific recommendations. I. Disconnect both battery cables (negative first, then positive) and remove the battery hold-down or retainer clamp. See Figure 1 for a typical open installation and Figure 2 for a typical enclosed installation. NOTE Some batteries have a carry strap built in for use in Step 2. See Figure 3. 2.
Attach a battery carrier or carrier strap to the terminal posts and lift the battery from the battery tray. Remove the battery from the engine compartment. 3. Check the entire battery case for cracks or other dam- age. 4. If the battery has removable vent caps, cover the vent holes in each cap with small pieces of masking tape. NOTE Keep cleaning solution out of the battery cells in Step 5, or the electrolyte will be seri- ously weakened. 5. Scrub the top of the battery with a stiff bristle brush, using a baking soda and water solution (Figure 4). Rinse the battery case with clear water and wipe it dry with a clean cloth or paper towels.
Remove the masking tape from the filler cap vent holes, if so equipped. 6. Inspect the battery tray or container in the engine com- partment for corrosion. Remove and clean it, if necessary, with the baking soda and water solution. Rinse it with clear water and wipe it dry, then reinstall. 7. Clean the battery cable clamps with a stiff wire brush or one ofthe many tools made for this purpose (Figure 5). The same tool is used for cleaning the battery posts (Fig- ure 6). 8. Reposition the battery on the battery tray or container and remove the carrier or strap. Install and tighten the hold-down device. 9. Reinstall the positive battery cable, then the negative battery cable.
Battery post cleaning tool CAUTION Be sure the battery cables are connected to their proper terminals. Reversing the polar- ity can damage the alternator.