190 C HA PTE R N INE potential problem. When charging system trouble is first suspected. pe rfonn the following: 4. Swivel the alternator toward the engine and remove the drive belt from the alternator pulley. 5. Support the alternator with one hand and remove the adjusting and pivot bolts. noting the position of any wash- ers or spacers used. Remove the alternator. 6. Installation is the reverse of removal. Tighten fasteners secure ly and adjust drive belt tension (Chapter Thr ee) be- fore reconnecting wiring harnesses and leads to the rear of the alternator. 1. Check the alternator drive belt for correct tension (Chapter Thr ee). 2.
Check the battery to make sure it is in satisfactory con- dition and fully charged and thai all connections arc clean and secure. 3. Che ck all con nections at the alternator 10 make sure they are clean and secure. 4. Ifth c charging system is nor performing as it should af - ter each of the abov e points has been carefully checked and any unsatisfactory conditions corrected. refer to Chapter Two and perfo nn the Charging System Tests. - NOTE Make sure the rubber boats at the end of the wires fi l snugly over the terminals on the al- ternator;otherwise, the wire end .. and termi- nal. s may corrode.
Alt ern ato r R emovat/l nstaltatton STAR Tl I\G S YSTE M This section provides alternator replacement proce- dures. Com plete alternator overhaul is not practical for the home mechanic. In some cases. replac ement parts are unavailable. The starti ng system consists of the battery, starter mo- tor, starter solenoid. starter switch, key switc h, fuse and connecting wiring. Sec Fi gur e 12, typical. Thi s procedure is generalized to cover all applications. Access to the alternator is quite limited in some engine compartments and ca re should be taken to avoid personal inj ury, I . Disconnect the negative battery cab le. 2.
Disconnect all wiring harnesses and leads at the rear of the alternator. See Figu re 13. typical. Yanmar marine engines are equ ipped with a Hitachi starter m otor . The starter solenoid is enclosed in the drive housing to protect it from exposure to dirt and adverse weather co nditions, Starter service requ ires experience and special tools. Refer to Chapter Two for troubleshooti ng procedu res. The procedures described below consist of re mova l, installa- tion and brush replacement. Any repairs inside the unit it- self (other than brush replacement) should be perf ormed by a dea ler or certified electrical shop.
Installation of a pr of essionally rebu ilt marine-type unit is gene rally less expensive and more practical. NOTE Whell loosening the retaining nut on an al- temator terminal, hold the terminal with a wrench to prevent the terminal from rotat- ing Starter Removal/Ins tallation 3. Loosen the alternator adjusting and pivot bolts (Figure 14. typical). I. Disconnect the negative battery cable.