ELECTRICAL SYSTEM 195 I ~ Sta rt Switch The start switch mounted on the instrument panel is a push-button switch that closes the starter motor circuit when the button is depressed. Perform voltage or resistance checks to determine if the switch is operating properly. ...---, Warn ing lamp Fus e l- Key sw itc h 9 ~ Battery B attery Cut off Switch The battery cutoff switc h is con nected between the pos- itive terminal of the battery and the starter solenoid. The switch provides a means to cutoff all circuits from the bat- tery in case of fire or othe r electrical eme rgencies. Using the cutoff switch also prevents any electrical drain on the battery.
To test the switch, check for voltage at the starter sole- noid terminal, or disconnect the positive battery cable and check the switch using an ohmmeter. 011 pressure se nder SWITCHES The instrument panel is equipped with two switches: a key switch and a start switch. A lighting switch is also used on instrument panels equipped with a tachometer. Most engines are also equipped with a battery cut off switch. Refer to the following sections to check the opera- tion of these switches. Also refer to the wiring diagrams at the back of this manual.
SEND ERS The engine is equipped with senders that trigger warn- ing lights and the alarm buzzer if eng ine oil pressure or water temperature reaches a dangerous level. The senders are essentially switches that complete an electrical circuit. Oil Pr essur e Se nder Key Switch Refer to the oil pressure circuit in Figur e 22. The sender is closed at zero oil pressure, which allows current to light the warning lamp and sound the alarm buzzer when the key switch is on. When oil pressure rises above 9.8-29A kl'a (I A-4.3 psi), the sender opens, the warning lamp goes out and the alarm buzzer quits. The key switch is mounted on the instrument panel.
When the key is in the ON position, the switch directs cur- rent to the circuits it controls. Perform voltage or resistance checks to determine if the switch is operating properly. The oil pressure sender on 10M and I OMl Ois located on the oil filter adapter as shown in Figure 23. The oil