196 CHAPTER NINE Waming lamp K.y Swit ch 1 : Banery Fu ~ ~ ~ lI: ~:"- Oil pres sure ::; sender Cootant temperature sender pressure sender on 2GM, 2GM20. JGM, 3GM30, 3HM and J HM35 engines is located below the oil filler as shown in Figul"e 24. To check the oil pressure sender, proceed as follows: CAUTION Before checking the oil pressure sender, make sure the engine is filled with oil. I. Disconnect the wire at the sender terminal. 2. Connect an ohmmeter between the sender terminal and the hex on the base of the sender. 3. With the engine off the meter should show continuity. 4. Start the engine.
As the oil pressure builds abo ve 9.R kPa (1.4 psi), the meter should switch from continui ty to no continuity. If it docs not, replace the sender unit. C). Engines equipp ed with freshwater cooling arc equipped with a sender that is color-coded green and has a closed temperature of 193-202° F (89_95° C). To check the coolant sender, proceed as follows: I. Remove the switch from the engine. 2. Connect a digital ohmmeter to the switch. 3. Immerse the sending unit and a cooki ng thermometer in a container of oil. 4. Heat the container over a flamclcss heat source and note the ohmmeter reading. The switch should close as follows: a. seawater switch (white)-148-154 ° F (63-67 ° C). b.
freshwater switch (g recn}-- 193-202 Coolant T emp er a tur e Send er Refer 10 the coolant temperature circuit in Fi gur e 25, The sender is open at ambient temperature, which pre- vents current from lighting the warning lamp and activat- ing the alarm buzzer. Whcn coo lant rises above the specification. the sender closes, the warning lamp and the alarm buzzer come on. On IGM and IGM 10 engines, the coolant temperature sensor is located on the cylinder head (f igure 26). The coolant temperature sensor on two or three cylinder en- gines is located on the front or side of the thermostat hous- ing (Fig ur e 27 ,t ypical). Q F (89-95 ° C). 5. Remove the conta iner from the heat and let it cool.
The switch should reopen as follows: a. seawater switch (white}--136° F (58° C). b. freshwater switch (g reen}-- I90° F (88° C). 6. Replace the switch if'it does not function as specified at each temperature range. Two different senders may be used depending on the type of cooling system. Engines equipped with seawater cooling are equipped with a sender that is color-coded white and has a closed temperature of 148-154° F (63-67°