Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

TRANSMISSION-KM SERIES 201 SHIFTER (KM2P AND KM3P MODELS) 14 J 15 / ~ \~ 13 16 17 8 10 1. Shoulder bolt 2. Connector 3. Shift lever 4. Washer 5. Nut 6. Stop bolt 7. Shims 8. Bolt 9. Seal 10. Bolt 11. Shift body 12. D-ring 13. Shift shaft 14. Detent pin 15. Pin 16. Spring 17. Shifter forces the shifter to push the clutch cone into the gear. The springs in the shift actuator hold the shifter in position. The shifter mechanism on Model KM2P and KM3P transmissions includes a spring-loaded shifter (Figure 4). Movement of the shift lever forces the shifter to move the cone clutch against the forward or reverse gear. Detent notches in the shift housing hold the shifter pin in posi- tion.

sary, refer to Chapter Five for single-cylinder models and Chapter Six for multi-models. 1. If not previously disconnected, disconnect the remote control cable from the transmission shift lever. 2. If not previously disconnected, disconnect the drive coupling from the transmission drive flange. 3. Remove the bolts that secure the transmission to the engine bellhousing. 4. Remove the transmission from the engine. REMOVAL/INSTALLATION 5. Reinstall the transmission by reversing the removal procedure. Make sure to align the splines on the transmis- sion input shaft and the drive disc during installation. Tighten the transmission retaining bolts to the torque specified in Table 2.

The following procedure addresses units that are acces- sible. In some cases, it may be necessary to remove the en- gine and transmission as a unit before removing the transmission from the engine. If engine removal is neces-