Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

TRANSMISSION KMSERIES 207 h. Tighten the nut (left-hand threads) to the torque specified in Table 2. Neutral hole 1. Make sure the gears rotate freely. j. Stake the nut to lock the nut in place. Ramp Shifter (KM2A, KM2C and KM3A models) Refer to Figure 20. 1. If not previously removed, detach the cotter pin and re- move the actuator from the shift lever. 2. Remove the shifter. NOTE Make alignment marks on the shift lever and shift shaft so the shift lever can be rein- stalled in its original position. Neutral notch 3. Loosen the clamp bolt and remove the shift lever. NOTE The setscrew and plug contain the springs and may fly out. 4.

Remove the setscrew and plug, then remove the springs and detent pins. 5. Remove the shifter shaft. 6. Remove and discard the O-ring. 7. Use a screwdriver or suitable tool to pry out the seal. Be careful not to damage the bearing. 8. Inspect the bearing. Ifit is faulty, replace it as follows: a. Heat the shifter body to 212 0 F (l00° C), then drive out the bearing. b. Install the new bearing with the stamped end out. Push in the bearing until it bottoms. 9. Inspect the shift shaft. Check the detent portion of the shaft for cracks or excessive wear that will allow poor clutch engagement. The ramps should be smooth and the neutral detent hole should be unworn (Figure 21). 10.

Inspect the detent pins. Replace the pins if they are damaged or excessively worn. 11. Inspect the springs for deformation or other damage. Specified spring free length is 34 mm (1.34 in.). 12. Inspect the shifter for damage and excessive wear. Measure the shifter width and shaft diameter. Replace the shifter if the measurements exceed the specifications in Table 6. 13. Check the internal movement of the actuator. The ac- tuatorshould slide without binding. To check spring ten- sion, attach a spring scale to the threaded end of the actuator and measure the spring tension when the actuator rod is pulled 5 mm (0.20 in.) from the end of the tube (Fig- ure 22).

If the spring tension is not as specified in Table 6, replace the spring. a. If reinstalling the original clutch cone, install it in its original position-forward end toward the forward gear. b. Install the pin before installing the inner roller bear- ing race. c. Use a suitable tool or sleeve to drive the inner roller bearing race onto the shaft. Do not use excessive force. Drive the race onto the shaft until it bottoms. d. Use a suitable tool or sleeve to drive the tapered roller bearing onto the shaft. Do not use excessive force. Drive the bearing onto the shaft until it bot- toms. e. On KM2P and KM3P transmissions-Install the spring cups so the cupped side is toward the gear. f.

Install each thick thrust washer so the stepped side is toward the tapered roller bearing. g. Install the washer so the pin in the output shaft fits in the groove in the washer.