Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

208 CHAPTER TEN 14. Reassemble the shifter by reversing the disassembly procedure. Note the following during reassembly: a. Apply sealant to the detent setscrew threads. b. Install the shift lever on the shift shaft while align- ing the marks made during disassembly. c. If no alignment marks are available when installing the shift lever, rotate the shift shaft so the shifter bore is down as shown in Figure 23. The shift shaft should engage the neutral detent. Install the shift le- ver at a 45° angle as shown in Figure 23. d. Install the shift lever on the shift shaft so the side clearance between the lever and body is approxi- mately 0.5 mm (0.020 in.).

}--''I+~'+-_ Shifter bore Refer to Figure 24. 1. If not previously removed, remove the control cable connector from the shift lever. 2. Remove the shifter and spring. 3. Remove the stop bolt and shims. 4. Loosen the clamp bolt and remove the shift lever. 5. Remove the shifter shaft. 6. Remove and discard the O-ring. 7. Use a screwdriver or suitable tool to pry out the seal. Be careful not to damage the bearing. 8. Inspect the shift shaft. Check the detent pin for damage and excessive wear. If necessary, replace the detent pin. Measure the shifter shaft bore in the shift shaft and com- pare with the specifications in Table 7. 9.

Inspect the body for galling, scoring or other damage to the bore. Inspect the detents for damage and excessive wear that will cause poor clutch engagement (Figure 25). 10. Inspect the spring for deformation or other damage. Specified spring free length is 22.6 mm (0.89 in.). Mini- mum spring length is 19.8 mm (0.78 in.). II. Inspect the stop bolt. Replace it if it is excessively worn. 12. Inspect the shifter. Measure the large diameter of the shifter shaft and compare it with the specifications in Ta- ble 7. 13. Reassemble the shifter by reversing the disassembly procedure, but do not install the stop bolt until final instal- lation of the shifter assembly on the transmission. 14.

Reassemble the shifter by reversing the disassembly procedure. Note the following during reassembly: a. Do not install the stop bolt until final installation of the shifter assembly on the transmission. b. Rotate the shift shaft so the detent pin engages the neutral detent (Figure 25). On the KM2P transmis- sion, install the shift lever so the side with the trian- gle mark (A, Figure 26) is out. On. the KM3P Shifter (KM2P and KM3P models) transmission, install the shift lever so the side with the triangle mark is toward the shifter body. With the shift shaft in neutral, position the shift lever at a 45° angle as shown in Figure 26 and tighten the clamp bolt.

REASSEMBLY NOTE On KM2P and KM3P transmissions, refer to the Bearing Adjustment section prior to reassembly if the following components have been replaced: input shaft, input shaft bearings, output shaft, thrust washers and output shaft bearings. I. If removed, install the outer bearing races into the transmission case and mounting flange. 2. Apply sealer to the outside diameter of the oil seals and install them into the transmission case and mounting flange with the open side to the inside. 3. Install the input shaft into the transmission case. 4. Install the intermediate shaft assembly into the trans- mission case. Install a new O-ring on the intermediate shaft.

Use a soft-faced hammer to tap the shaft into the case. 5. While holding the input shaft out of the way, insert the output shaft assembly into the transmission case. Move the gears into mesh on the intermediate shaft, input shaft and output shaft while installing the output shaft. 6. Ifthe following components have been replaced, refer to the Bearing Adjustment section: input shaft, input shaft bearings, output shaft, thrust washers and output shaft