Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

210 CHAPTER TEN bearings. After adjusting the bearings, continue to reas- semble the transmission as described in the following steps. If the preceding components have not been re- placed, bearing adjustment is not necessary and the orginal shims may be reused. Proceed to the following step. 7. Position the transmission on a vise with soft jaws so the input shaft is held by the vise jaws. 8. Apply sealer to the mounting flange and install it onto the transmission case. 9. Tighten the mounting flange retaining bolts to the torque in Table 2. 10. Install the output flange on the output shaft. 11. Install the a-ring on the output shaft.

Reverse '\ NOTE The output flange retaining nut has left-hand threads. 12. Install the output flange retaining nut by rotating the nut counterclockwise (left-hand threads). Tighten the nut to the torque specified in Table 2. 13. Stake the nut to lock the nut in place. 14A. On KM2A, KM2C and KM3A transmissions-In- stall the shifter assembly on the transmission using the following procedure: NOTE Note that the bolt holes in the shifter mount- ing flange are sufficiently large to allow movement of theflange around the bolts. a. Install the shifter assembly on the transmission and tighten the retaining bolts. b.

Measure the amount of shift lever travel from neu- tral to forward and from neutral to reverse (Figure 27). The measurement should be equal from neutral to either forward or reverse. c. Loosen the shifter retaining bolts and slide the shifter assembly fore or aft as needed to obtain equal shift lever movement. 14B. On KM2P and KM3P-Install the shifter assembly on the transmission using the following procedure. a. Position the shifter so its curvature is as shown in Figure 28. b. Install the shifter assembly on the transmission and tighten the retaining bolts. c. Move the shift lever 10-15° from the neutral posi- tion to either forward or reverse position. d.

Measure the depth of the end of the shifter shaft from the end of the shift shaft as shown in Figure 28. Measure the length of the stop bolt (Figure 29). Bolt length ~ e. Subtract the length of the stop bolt from the shifter shaft depth. f. Install shims on the stop bolt that equal the result of substep e.