TRANSMISSION-KM SERIES 211 g. Apply sealer to the stop bolt threads, but not to the threads at the end of the bolt (approximately 0.20 in.). Install the stop bolt into the shifter. Input shaft BEARING ADJUSTMENT Perform the following procedure if the following com- ponents have been replaced: input shaft, input shaft bear- ings, output shaft, thrust washers and output shaft bearings. This procedure determines the thickness of shims that must be installed so the tapered roller bearings properly contact the bearing outer races. KM2A, KM2C and KM3A 1. Install the input shaft, intermediate shaft and output shafts as described in the Reassembly section. 2.
Position the transmission case so the open end is up and no pressure is being applied to the splined end of the output shaft. 3. Install the outer bearing races on the input and output shaft tapered bearings. 4. Measure the distance (A, Figure 30) in millimeters from the mounting flange mating surface on the case to the top of each bearing race. Record the measurements. 5. Measure the distance (B, Figure 31) from the mount- ing flange mating surface to the bottom ofthe bearing race bore for both the input and output shaft bearings. 6. Subtract the A measurement from the B measurement for each shaft. 7. From the result obtained in Step 6, subtract 0.0-0.05 mm.
This result equals the thickness of the shim(s) that must be installed in the bearing bores in the mounting flange. 8. Install the shim(s) in the bearing bores in the mounting flange, then press the bearing outer races into the mount- ing flange on top of the shims. Make sure the races are bottomed. Output shaft Input shaft B KM2P and KM3P NOTE The following procedure for adjusting the input shaft bearings is similar to the proce- dure for the KM2A, KM2C KM3A transmis- sions, but only use the callouts in Figure 30 and Figure 31 that pertain to the input shaft.