Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

212 CHAPTER TEN 1. Install the input shaft assembly in the transmission case. 2. Position the transmissi~n case so the open end is up. 3. Install the outer bearing race on the input shaft tapered bearing. 4. Measure the distance (A, Figure 30) in millimeters from the mounting flange mating surface on the case to the top of the bearing race. Record the measurement. 5. Measure the distance (B, Figure 31) from the mount- ing flange mating surface to the bottom ofthe bearing race bore for the input shaft bearing. 6. Subtract the A measurement from the B measurement. 7. From the result obtained in Step 6, subtract 0.0-0.05 mm.

This result equals the thickness of the shim(s) that must be installed in the bearing bore in the mounting flange. 8. Install the shim(s) in the bearing bore in the mounting flange, then press the bearing outer race into the mounting flange on top of the shims. Be sure the race is bottomed. Output Shaft In the following procedure to adjust bearing preload, the neutral position of the clutch cone must be established for proper transmission operation. The desired clutch cone groove centerline on Model KM2P is 48.3 mm from the mating surface of the transmission case. On Model KM3P the desired clutch groove centerline is 47.3 mm from the mating surface of the transmission case.

B NOTE To perform the following bearing adjust- ment procedure, the output shaft must be out of the case and the outer bearing races must be on the bearings and not installed in the case or mountingflange. 5. Measure and record the distance (E, Figure 34) from the face ofthe reverse gear and the face ofthe rear bearing race. 6A. On KM2P transmissions-To determine rear shim thickness (Figure 35), proceed as follows: a. Subtract 48.3 mm from measurement (B, Figure 33). b. Divide measurement (D, Figure 34) by 2. c. Subtract substep b from substep a. d. Subtract measurement (E, Figure 34) from substep c. e. Subtract 0.0-0.05 mm from substep d. The result is the required rear shim thickness. 6B.

On KM3P transmissions-To determine rear shim thickness (Figure 35), proceed as follows: 1. Measure and record the distance (A, Figure 32) from the mounting flange mating surface to the bottom of the bearing race bore for the output shaft bearing. 2. Measure and record the distance (B, Figure 33) from the mounting surface of the case to the bottom ofthe bear- ing race bore for the output shaft bearing. 3. Measure and record the distance (C, Figure 34) from the faces of the output shaft bearing races. NOTE In Steps 4 and 5, force the gears toward the cone clutch. 4. Measure and record the distance (D, Figure 34) be- tween the faces of the forward and reverse gears.