Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

TRANSMISSION- KM SERIES 213 rc -l D-1 ~ E J b. Subtract measurement (C, fo "igure 34) from substcp a. c. Subtract the rear shim thickness (determined in Step 6A) from Step b. d. Subtract 0.0-0.05 mm from substep c. The result is the required front shim thickness. 8. Install the shim(s) in the bearing bores in the mount ing Rear s him Front shim flange and case, then press the bearing ourer races on top of the shims. Make sure the races are bortomed. DRIV E DISC The drive disc attached to the engine flywheel transmits power from the engine flywhee l to the transmission input shaft.

Bolts secure the disc to the flywheel while the trans- mission input shaft engages the splined hub on the drive disc. The drive disc incorporates springs that dampen drivelinc shocks between the engine and transmissio n. to Removal/Installatlon 1. Remove the engine from the boat. 2. Remove the transmission. 3. Remove the drive disc (Figure 36, typical). 4. Install the drive disc by revers ing the removal proce- dure. Install the drive disc so the side marked FLYWHEEL SIDE (Figure 37) is toward the flywheel. Tighten the drive disc retaining bolls to the torque speci- fied in Table 2. a. Subtract 47.3 mm from measurement (B. Figure 33). b. Divide measurement (D. Fi gure 34) by 2. c.

Subtract substep b from substcp a. d. Subtract measurement (E. Fi gure 34) from substep Inspection c. e. Subtract 0.0-0.05 mm from substep d. The result is the required rear shim thickness. 7. To determine front shim thickness (Figure 35), pro- ceed as follows: Replace the drive disc if any ofthe following conditions exist: I. Broken spring. 2. Worn or damaged splines in hub. 3. Damaged disc. 4. Damaged pins. a. Add measurement (A, Figure 32) to measurement (8 , Figu re 33 ).