Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

Chapter Eleven Transmission-KBW Series This chapter covers the Kanzaki Hurth KBWlOD and KBWIOE marine transmissions that are attached to Yanmar 3GM, 3HM and 3HM35 engines. Refer to Table 1 for a cross-reference of engine and transmission models. The identification plate (Figure 1) located on the trans- mission case specifies the transmission model. The KBWlO series transmissions covered in this chap- ter are inline transmissions that provide forward and re- verse direction. All gears are constant mesh. A plate-type clutch engages the gears to transmit power to the output shaft. Oil contained in the transmission case lubricates the internal transmission components.

Refer to Chapter Three for maintenance information. Tables 1-3 are located at the end of this chapter. o MARINE GEAR MODEL KBW 10 o GEAR RATIO OIL ATF·A No. o OSAKA f!.'!!f1/~_1fJ JAPAN 0 OIL OTY. o. 7 LTR. shown engaged with the forward gear. Because power flows from the input shaft gear through the reverse idler gear to the reverse gear, the reverse gear rotates in the op- posite direction of the forward gear. When the clutch en- gages the reverse gear, the output shaft rotates in reverse. Moving the shift lever rotates the shift shaft. When the shift shaft rotates, the shifter fork slides the shift ring into engagement with the forward or reverse gear clutch.

The drive hub on the output shaft transfers power from the se- lected clutch to the output shaft. OPERATION The input shaft on the transmission engages the drive disc attached to the engine flywheel. Because this is a con- stant-mesh transmission, engine power is transmitted to all gears. Power flows to the output shaft when the clutch engages either the forward gear or the reverse gear. The clutch contacts a clutch pack of several discs adjacent to the forward and reverse gears. In Figure 2, the clutch is