TRANSMISSION-KBW SERIES 217 Input shaft Disassembly 1. Remove the drain plug and drain the transmission oil. 2. Position the transmission in a vise with soft jaws so the input shaft is held by the vise jaws. 3. The output flange retaining nut is staked. Use a chisel to cut away the staked portion so the nut will rotate. 4. Install a tool that will prevent rotation of the output flange. 5. Unscrew the output flange retaining nut. 6. Remove the oil dipstick. 7. Make match marks on the shifter cover and the trans- mission case so the shifter can be installed in its original position. 8. Remove the shifter retaining bolts and remove the shifter assembly. 9. Remove the transmission from the vise.
10. Using an 8 mm Allen wrench, remove the shift bar re- taining plug (68, Figure 3) in the rear of the case. 11. Install a 10 mm bolt into the end of the shift bar, then pull the shift bar (58, Figure 3) out of the case while also removing the shift fork (57). 12. Remove the transmission mounting flange retaining bolts. Coupling flange REMOVALIINSTALLATION The following procedure addresses units that are acces- sible. In some cases, it may be necessary to remove the en- gine and transmission as a unit before removing the transmission from the engine. Refer to Chapter Six if en- gine removal is necessary. 1.
If not previously disconnected, disconnect the remote control cable from the transmission shift lever. NOTE In Step 13, position the transmission so the transmission input shaft is up when remov- ing the mountingflange so the transmission shafts will not fall out. 2. If not previously disconnected, disconnect the drive coupling from the transmission drive flange. 3. Remove the bolts that secure the transmission to the engine bellhousing. 13. Tap on the mounting flange using a soft-faced ham- mer to dislodge the flange. Position the transmission with the input shaft up, then remove the flange from the trans- mission case. 14.
Remove the output shaft assembly from the transmis- sion case and set aside for disassembly. 15. Remove the intermediate shaft assembly from the transmission case and set aside for disassembly. 16. Remove the input shaft assembly from the transmis- sion case and set aside for disassembly. 17. Using a large screwdriver, pry out the oil seal in the transmission case. Be careful not to damage the case or the adjacent bearing race. 18. Using a large screwdriver, pry out the oil seal in the transmission mounting flange. Be careful not to damage the case or the adjacent bearing race. 19. If inspection indicates additional disassembly is nec- essary, refer to the following sections. 4.
Remove the transmission from the engine. 5. Reinstall the transmission by reversing the removal procedure. Make sure to align the splines on the transmis- sion input shaft and the drive disc during installation. Tighten the transmission retaining bolts to the torque specified in Table 2. OVERHAUL Refer to Figure 3. NOTE Overhaul of the KB W transmission requires special tools, which can be obtained from Yanmar or fabricated. If the special tools are not available, have a Yanmar dealership overhaul the transmission.