Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

220 CHAPTER ELEVEN Input shaft 1. Check the gear teeth for excessive wear, corrosion or rust and mechanical damage. Check the teeth for galling, chips, cracks, missing pieces, distortion or discoloration from overheating. Replace the input shaft if the gears are damaged. 2. Inspect the input shaft bearings and seal surfaces for excessive wear, grooves, metal transfer and discoloration from overheating. Use a press to remove damaged bear- ings and to install new bearings. NOTE Shims (39, Figure 3) behind the outer bear- ing race in the mounting flange determine bearingpreloadfor the input shaft bearings. Save the shims and reinstall them ifreusing the original parts. 3.

Inspect the input shaft bearing outer races in the trans- CD mission case and mounting flange. If either race is dam- aged or excessively worn, remove it using a suitable puller. Intermediate shaft 1. Remove and discard the O-ring (46, Figure 3) at the end of the shaft. 2. Remove the thrust washer (47, Figure 3), idle gear (45) and roller bearings (44). 3. Inspect the bearings, shaft and reverse idler gear inside diameter for excessive wear, grooves, metal transfer and discoloration from overheating. If necessary, replace the shaft, gear and bearings. 4. Check the idler gear teeth for excessive wear, corro- sion or rust and mechanical damage.

Check the teeth for galling, chips, cracks, missing pieces, distortion or discol- oration from overheating. If necessary, replace the gear. 5. Reassemble the intermediate shaft. Install a new O-ring on the shaft. Check that the idler rotates freely on the shaft. 2. Remove the spacer (9, Figure 3) and the bearing inner race (7) from the output shaft. 3. Hold the threaded end of the output shaft so the threads are protected. 4. Place the outer race onto the front bearing inner race. Using a suitable bearing driver, gently drive the inner bearing race away from the shaft collar approximately 10 mm. 5.

Place a pulling support plate (such as Yanmar special tool 17099-09030) between the collar of the output shaft and bearing. 6. Use Yanmar special tool 17095-09070, or a suitable equivalent tool, to press the bearing off the shaft, as shown in Figure 5. 7. Remove the clutch friction plates (14, Figure 3) and steel plates (15) from the forward gear (10). 8. Use Yanmar special tool 17095-09070, or an equiva- lent tool, to compress the Belleville springs (11, Figure 3) and remove the snap ring from the forward gear, as shown in Figure 6. Output shaft NOTE Exercise care when using the puller in Step 1. Make sure the threads on the output shaft are not damaged. 1.

Using a suitable puller, remove the output shaft from the forward and reverse gear assemblies as shown in Fig- ure 4. Do not mix the forward gear parts and reverse gear parts.