Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

TRANSMISSION-KBW SERIES 221 2. Inspect the output shaft bearings and seal surfaces for excessive wear, grooving, metal transfer and discolor- ation from overheating. 3. Inspect the key and output shaft keyway for damage. NOTE Shims behind the outer bearing race in the mountingflange determine bearingpreload for the output shaft bearings. Save the shims and reinstall them if reusing the original parts. 4. Inspect the input shaft bearing outer races in the trans- mission case and mounting flange. If either race is dam- aged or excessively worn, remove it using a suitable puller. 5. Measure steel plate warpage as shown in Figure 7 and compare the result with the specification in Table 3. 6.

Measure the width of the steel plates tangs and com- pare the result with the specification in Table 3. 7. Measure the width of the grooves in the pressure plates and compare the result with the specification in Table 3. The clearance between the tangs and the grooves should be 0-0.6 rom (0-0.024 in.). 8. Measure the width of the friction plates and compare with the specification in Table 3. Both sides of friction plates have a 0.35 mm (0.014 in.) copper sintered layer. Replace the friction plates when the copper layer is worn more than 0.2 rom (0.008 in.) on one side. 9. Measure four friction plates.

The sum of wear of four friction plates (forward or reverse) must not exceed 0.8 mm (0.031 in.). If wear exceeds 0.8 rom (0.031 in.), re- place all friction plates (forward or reverse). 10. Assemble each set of steel and friction plates. Com- press the plates to remove steel plate warp. Measure the assembled plates. The assembled thickness must exceed 10.0 mm (0.394 in.). 11. Measure the backlash between the teeth on the fric- tion plates and the gear splines. The backlash must not ex- ceed 0.9 mm (0.035 in.). 12. Lay the shift ring and pressure plate assembly flat and remove the pressure plate return springs (24, Figure 3).

Lift off the top pressure plate (17) and remove the steel balls (18). 13. Lift the shift ring (25, Figure 3) and driving plate (22) off the bottom pressure plate and remove the three re- maining steel balls. Slip the shift ring (25) off the driving plate (22), remove the alignment pins (21) and detent pins (20) with the springs (19) from the driving plate (22). 14. Inspect the pressure plate (17 and 23, Figure 3) ball grooves for wear and renew the plate if wear is noticeable. 15. Measure the pressure plate thickness and compare the result with the specification in Table3. 9. Refer to Steps 7 and 8 and disassemble the clutch com- ponents on the reverse gear. 10.

Lay the shift ring and pressure plate assembly flat. 11. Remove the pressure plate return springs (24, Figure 3), then lift off the top pressure plate (17) and remove the steel balls (18). 12. Lift the shift ring (25, Figure 3) and driving plate (22) off the bottom pressure plate and remove the three re- maining balls. 13. Slip the shift ring (25, Figure 3) off the driving plate (22). 14. Remove the alignment pins (21, Figure 3) and detent pins (20) with springs (19) from the driving plate (22). Inspection I. Check the gear teeth for excessive wear, corrosion or rust and mechanical damage.

Check the teeth for galling, chips, cracks, missing pieces, distortion or discoloration from overheating. Check the splines for excessive wear or damage. Replace the gears if damaged.