Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

34 CHAPTER TWO FUEL INJECTION SYSTEM / Fuel return hose Fuel filter ~~W"'---- High pressure fuel pipe described in Chapter Seven to remove air in fuel. Check for a clogged or defective fuel injection pump or fuel in- jector. 6. Engine knocks-Check the fuel injection pump timing as described in Chapter Seven. Check for a defective fuel injection pump. WARNING Wear goggles and protective clothing when performing the next procedure. Diesel injec- tors can spray with sufficientforce to pene- trate the skin. Have afire extinguisher rated for fuel and electricalfires on hand. COOLING SYSTEM The engine may be equipped with a seawater cooling system or freshwater cooling system.

Refer to Chapter Eight for identification and description ofthe cooling sys- tem. To identify a faulty fuel injector on multicylinder en- gines, loosen the fuel injector fuel line nut with the engine running to reduce fuel pressure (only slight loosening is required). If the engine runs worse, the injector is operat- ing satisfactorily. If the engine runs the same, the injector or the fuel injection pump is not operating properly. If no fuel appears at the fuel line, the fuel injection pump is de- fective. Engine Overheating A problem in the cooling system generally causes en- gine overheating; however, other engine problems can also cause overheating.

Note the possible causes in the following list: