TROUBLESHOOTING 35 1. Loose pump drive belt (except IGM models)-A loose drive belt prevents the circulating pump from operating at the proper speed. Black Smoke Black exhaust smoke results from excess fuel (rich) that forms soot when burned. Either excess fuel or insufficient air can cause black smoke. Some possible causes are a de- fective fuel injection pump, poor injector spray pattern, low injection opening pressure, clogged air intake, re- stricted exhaust system or low compression pressure. 2. Loose hose or pipe connections-Air may be drawn into the suction side of the system. 3. Worn or defective water pump-A worn or defective pump may not provide sufficient cooling water. 4.
Dirty cooling system-Debris in the cooling system prevents adequate heat transfer to the cooling water. ENGINE NOISES 5. Defective or incorrect thermostat-A defective ther- mostat may stay closed or not open sufficiently to allow hot water to leave the engine. An incorrect thermostat may open at a temperature higher than specified, thereby raising the temperature of the cooling water in the engine. Conversely, a thermostat that stays open and doesn't close or opens at a low temperature will cause the engine to run at less than optimum temperature. Often the first evidence of an internal engine problem is a strange noise.
That knocking, clicking or tapping sound never heard before may be warning of impending trouble. While engine noises can indicate problems, they are difficult to interpret correctly; inexperienced mechanics can be seriously misled by them. Remember that diesels are much noisier than gasoline engines and have a normal clatter at idle, especially when cold. It is necessary to become accustomed to these nor- mal noises in order to detect possible problem-associated noises. Professional mechanics often use a special stethoscope for isolating engine noises.
The home mechanic can do nearly as well with a sounding stick, which can be an ordi- nary piece of dowel, a length of broom handle or a section of small hose. Place one end in contact with the area in question and the other end near the ear to hear sounds em- anating from that area. There are many strange sounds coming from even a normal engine. If possible, have an experienced mechanic help sort out the noises. ENGINE EXHAUST SMOKE The engine should emit colorless exhaust smoke or smoke that appears no more than a light haze. If the ex- haust smoke is black, white or blue, an engine problem exists. Blue Smoke Blue exhaust smoke indicates that oil is burning during the combustion process.
Look for a condition that allows oil to enter the combustion chamber, such as a broken pis- ton, broken or stuck piston rings, a damaged cylinder wall, worn valves or guides, a defective crankcase vent, or an overfilled oil sump. Clicking or Tapping Noises Clicking or tapping noises usually come from the valve train and indicate excessive valve clearance. A sticking valve may also sound like a valve with excessive clear- ance. In addition, excessive wear in valve train compo- nents can cause similar engine noises. White Smoke Knocking Noises Unburned fuel causes white exhaust smoke. The un- burned fuel may be due to retarded fuel injection timing or insufficient compression pressure.
Low compression pressure may be caused by a damaged cylinder gasket, broken piston rings, leaking valves or incorrectly adjusted valves. Raw, unburned fuel may be due to incorrect fuel (low cetane rating) or a defective injector. A heavy, dull knocking is usually caused by a worn main bearing. The noise is loudest when the engine is working hard, such as accelerating at low speed. It is pos- sible to isolate the trouble to a single bearing by disabling the fuel injectors on multicylinder engines one at a time. By disabling the fuel injector nearest the bearing, the knock will be reduced or disappear.
Worn connecting rod bearings may also produced a knock, but the sound is usually more metallic. As with a NOTE White smoke may also be due to coolant leaking into the combustion chamber.