36 CHAPTER TWO main bearing, the noise is worse during acceleration. It may increase in transition from acceleration to coasting. Disabling the fuel injectors will help isolate this knock as well. A double knock or clicking usually indicates a worn piston pin. Disabling fuel injectors on multicylinderengines will isolate this to a particular pis- ton; however, the noise will increase when the affected piston is reached. A loose flywheel and excessive crankshaft end play also produce knocking noises. While similar to main bear- ing noises, they are usually intermittent, not constant, and they do not change when fuel injectors are disabled.
If caused by a loose flywheel or coupling, the noise is gener- ally heard at idle or during rapid deceleration. It is a good idea to recheck flywheel/coupler bolt torque whenever ac- cessible. Some mechanics confuse piston pin noise with piston slap (excessive piston clearance). The double knock will distinguish piston pin noise. Piston slap will always be louder when the engine is cold. Chapter Seven to repair the governor. If a fuel system problem is suspected, refer to troubleshooting in the Fuel System section of this chapter. Engine Will Not Run Under Load Refer to troubleshooting in the Fuel System section in this chapter.
Low Oil Pressure Low engine oil pressure may be caused by leakage in the oil circuit, excessive bearing clearance, a clogged oil filter, a loose oil regulator valve or incorrect oil viscosity. Low oil pressure may also be caused by engine overheat- ing or oil dilution by fuel in the crankcase. Verify low oil pressure by performing the oil pressure test described in this chapter. If the engine is overheating, refer to troubleshooting in the Cooling System section in this chapter. ENGINE TROUBLESHOOTING COOLING SYSTEM These procedures assume the starter cranks the engine over normally. If not, refer to the Starting System section of this chapter.
The temperature warning lamp should signal cooling system problems before there is any damage. If the engine is stopped at the first indication of trouble, serious damage is unlikely. With standard cooling systems in which seawater is drawn into the engine, circulated and then expelled, cool- ing system problems are generally mechanical-a defec- tive pump or thermostat, a loose or broken drive belt or passages plugged with contamination. Closed cooling systems are more complex in that they use a heat exchanger, which transfers heat from the engine coolant to seawater without the two coming in contact.
The closed portion of the cooling system is pressurized (like an automotive cooling system) and uses a 50/50 mix- ture of ethylene glycol antifreeze and pure soft water. Check this system periodically to make sure it can hold pressure up to 13 psi. Heat exchangers used in closed cooling systems collect salt, lime and other contaminants in their passages, lead- ing to a gradual decrease in cooling efficiency. For this reason, they should be removed every two years and the seawater passages cleaned with a wire brush and com- pressed air. Engine Will Not Start This can be caused by the fuel system or by insufficient compression pressure.
Refer to troubleshooting in the Fuel System section of this chapter. Refer to Chapter Three and check valve adjustment. Check for low com- pression pressure by performing a compression pressure check as described in Chapter Three. Repair the engine as required to obtain the correct compression pressure. Engine Misses This can be caused by the fuel system. Refer to trouble- shooting in the Fuel System section of this chapter. Sticking intake or exhaust valves can also cause the en- gine to misfire. Engine Stops Suddenly This can be caused by engine seizure, a governor mal- function or a problem in the fuel system. Attempt to start the engine to determine if the engine rotates freely.
Refer to Chapter Three to check governor adjustment or to LUBRICATION SYSTEM Refer to Figure 10, Figure 11 and Figure 12 for lubri- cation system diagrams. A rotor type oil pump receives oil