Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

TROUBLESHOOTING 41 Trouble Probable cause Table 1 ENGINE TROUBLESHOOTING (continued) Correction Engine stops suddenly (continued) Governor malfunction Engine seized Engine slows unexpectedly Overload Fuel filter or fuel lines clogged Air in fuel system Water in fuel Misadjusted governor Piston or bearing seizure Repair governor Inspect and repair Locate cause for overload and rectify Inspect and unclog or replace Bleed air in fuel system Remove water Adjust governor Repair damaged components; determine cause Clean fuel filter Repair fuel feed pump Repair or replace fuel InJection pump Inspect and repair Inspect and repair Tighten bolt Adjust timing Inspect fuel injection pump and injectors Inspect and repair Inspect and repair Clean or replace filter element Repair oil pressure regulator valve Replace oil; check for dilution due to fuel leaking into crankcase Flush cooling system Replace thermostat Check water pump; check for blockage in system Fill with proper coolant Check for loose clamps and damaged hoses Engine will not run under full load Clogged fuel filter Faulty fuel feed pump Worn fuel injection pump Engine knocks Excessive bearing clearance Loose rod bolt Loose flywheel or coupling bolt Incorrect injection timing Excessive fuel injected into cylinder Low oil pressure Oil leaks Excessive bearing clearance Clogged oil filter element Faulty oil pressure regulator valve Low oil viscosity Overheating Dirty cooling system Faulty thermostat Insufficient coolant flow Insufficent coolant in closed system Air entering system Table 2 STARTER MOTOR NO· LOAD SPECIFICATIONS 3HM, 3HMF, 3HM35 All other models Model 12 12 Volts 90 60 Max.

amperage 4000 or higher 7000 or higher Speed (rpm) Table 3 OIL PRESSURE At 850 rpm all models At 3400 rpm 3HM and 3HM35 At 3600 rpm all models except 3HM and 3HM35 50 kPa (7 psi) 300-400 kPa (43-58 psi) 300-400 kPa (43-58 psi)