Chapter Three Operation, Lubrication, Maintenance and Tune-up A diesel engine must have clean air, fuel, and oil. Regu- lar preventive maintenance and proper lubrication will pay dividends in longer engine and transmission life, as well as safer boat operation. The lubrication and maintenance intervals provided in Table 1 are those recommended for normal operation. If the boat is used under continuous heavy duty or other se- vere operating conditions, including infrequent use, per- form maintenance and lubrication more frequently. Keep the engine and accessory units clean and free of dirt, grime and grease buildup. It is much easier and safer to perform service on a clean engine.
It is also much easier to pinpoint any leaks. NOTE Poor fuel is one of the leading causes of rough engine operation or failure to start. Dirty fuel or water in the fuel can cause expensive dam- age to the fuel injection pump and fuel injectors. Refer to Chapter Seven. PREOPERATIONAL CHECKS Before starting the engine for the first time each day, perform the following checks: 1. Remove the engine compartment cover or hatch and check for the presence of fuel fumes. If the boat is equipped with a bilge blower, tum it on for a few minutes. If the smell of strong fumes is present, determine the source and correct the problem before proceeding. Tables 1-6 are located at the end of this chapter.
NOTE Except where specified, F and D series en- gines are included when a basic model num- ber is specified. For example. if model 3GM is called out in a procedure. the procedure also applies to 3GMD and 3GMF. WARNING Always have a Coast Guard-approved fire extinguisher close when working around the engine. FUEL REQUIREMENTS 2. Check the engine oil level as described in this chapter. Add oil if the level is low. 3. Check the electrolyte level in each battery cell as de- scribed in this chapter. Add distilled water if necessary. The recommended fuel is number 2 (2-D) diesel fuel. Be sure the fuel is clean and free of water.