OPERATION, LUBRICATION, MAINTENANCE AND TUNE-UP 43 4. Check the condition of all drive belts. If a belt is in doubtful condition, replace it. 5. Check all water hoses for leaks, loose connections and general condition. Repair or replace as required. 6. Check the oil level in the transmission as described in this chapter. Add lubricant if necessary. 7. Check the bilge for excessive water; ifpresent, drain or pump dry. 8. Check the propeller for damage. Repair or replace the propeller if damaged. 9. Remove any water or dirt in the fuel tank by opening the fuel tank drain valve. 10. Check the fuel level in the fuel tank and add fuel as needed. 11.
Open the seacock and close any water drain valves. 12. Operate controls and check for free operation. 13. Connect the battery cables to the battery (if discon- nected). 14. Open the fuel tank valve. 15. Reinstall the engine compartment cover or hatch. CAUTION If the alarm buzzer or lamps remain on after the engine starts, stop the engine and deter- mine the cause. Engines Equipped With Remote Control Warm engine 1. If equipped with a bilge blower, operate it for at least five minutes before starting the engine. 2. Move the speed control lever to the MEDIUM SPEED position. 3. Rotate the key switch to the ON position. The alarm buzzer will come on.
WARNING Always have a fully charged fire extin- guisher on hand before attempting to start the engine. CAUTION Do not push the starter for more than I5 seconds, or the starter motor may be dam- aged due to overheating. STARTING CHECKLIST After performing the preoperational checks, observe the following starting procedure: 4. Start the engine by pushing the start button. The alarm lights and buzzer should go off. CAUTION If the alarm buzzeror lamps remain on after the engine starts, stop the engine and deter- mine the cause. Engines Without Remote Control 1. If equipped with a bilge blower, operate it for at least five minutes before starting the engine. 2.
Move the clutch control lever to the NEUTRAL posi- tion. 3. Move the speed control lever to the MEDIUM SPEED position. 4. Hold the decompression lever in the OPERATION po- sition. 5. Rotate the key switch to the ON position. The alarm buzzer will come on. Cold engine 1. If equipped with a bilge blower, operate it for at least five minutes before starting the engine. 2. Move the speed control lever to the HIGH SPEED po- sition. Injection timing is retarded when starting with the lever in the HIGH SPEED position. 3. Movethe decompression lever to theDECOMPRESSION position. 4. Rotate the key switch to the ON position. The alarm buzzer will come on.
WARNING Always have a fully charged fire extin- guisher on hand before attempting to start the engine. WARNING Always have a fully charged fire extin- guisher on hand before attempting to start the engine. CAUTION Do not operate the starter for more than I5 seconds, or the starter motor may be dam- aged due to overheating. CAUTION Do not operatedthe starter for more than 15 seconds, or the starter motor may be dam- aged due to overheating. 6. Start the engine by pushing the start button. The alarm lights and buzzer should go off.