44 CHAPTER THR EE 5. Start the engine by pushing the start button. while en- gaging the starter. move the decompression lever to the COMPRESSION position. The alarm lights and buzzer should go ofT. C AU T IO N If lhe alarm buzzer or lamps remain on after the engine starts, SLOp the engine a nd deter- mine the cause. 6. Move the speed controllever to the MEDI U~ SPEED position. 7. Allow the engine to warm for approximately five min- utes before applying full load to the engine. S T O P P I ~G Til E E:\'GIl'iE Note the following items when stopping the engine. 1. Place the transmission in neutral, then allow the engine to idle for five minutes bef ore stopping the engine. 2.
Momentarily raise engine speed 10blo wout any resi- due in the cylinders. then pullth e engine stop knob or le- ver. C AU T ION Do not Slop the engine us ing the dec ompre s- sion leve r: D oing so may leave su ffi cie ntf uel in the cylinders to damag e the engine when started. 3. Close the scacock. If ambient temperature is below freezing while the engine is not running, drain water in cooling system after engine has cooled. 4. Top offthe fu eltan k(s), i fpo ssiblc. This will minimize the possibility of moisture condensation in the tank(s). 5. If water is present in the bilge. either drain it or pump it dry. 6. Wash the interior and exterior surfaces of the boat with freshwater.
El\t ER GEN CY El'iGI.'IE S TOP P ING To safe ly stop a diesel engine when thc normal stopping controls are inoperative or ineffective, block the engine's air intake. A flat plate is desirable if it will adequately cover the opening. A rag may also be used, but do not al- low the rag to enter the engine. El'iG I:\IE i\1 i\I I'\ T" : l'i A ~ C E A:'\D LUB R ICA TIO:\l The maintenance tasks discussed in this section should be perform ed at the intervals indicated in Tab le I. These PO ST·O PERA TlO~AL CHECKS intervals arc only guidelines, however. Consider the fre- quency and extent of boat use when establis hing the actual intervals.
Perform the tasks more frequently if the boat is used under severe service conditions. Perform the following maintenance after each use. I. If the boat was used in salt or polluted water, flush the cooling system with freshwater as described in this chap- ter. This will minimize corrosion and buildup of deposi ts in the cooling system. 2. Disconnect the battery cables from the battery. nega- tive cable first. Remove the battery from the boat to pre- EnJ:inc Oil Engine oil designed for use in diesel engines must meet specifications particular to diesel eng ine operat ion. The Society for Automotive Engineers (SAE) specifies the '>'e n! theft. if necessary. 3. Shut off the fuel tank velvets ).