Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

OPERATION, LUBRICATION, MAINTENANCE AND TUNE-UP 45 To engine Whenever checking the oil level, always allow approxi- mately five minutes for the oil in the upper end to drain back into the crankcase oil pan. 1. With the boat at rest in the water and the engine off, pull out the dipstick. See Figure 1 for the typical location. Wipe it with a clean rag or paper towel, reinsert it and pull it out again. Note the oil level on the dipstick. 2. Add oil, if necessary, so the oil level reaches the full mark on the dipstick. Remove the oil fill plug (Figure 2) or oil filler cap (Figure 3) and add oil through the hole in the rocker arm cover.

criteria that engine oils must meet to attain a diesel engine oil classification ofCA, CB, CC or CD. The classification system ranges from CA for light diesel engine service to CD for severe diesel engine service. Yanmar specifies en- gine oils with classification CB or CC for use in the Yanmar diesel engines covered in this manual. Do not mix oil brands. For instance, do not add a differ- ent oil brand than what is in the crankcase when topping off the oil level, except if necessary. Use only a high-quality oil. Yanmar recommends Shell Rotella, Caltex RPM Delo, Mobil Delvac, Esso Standard and BP Energol. Refer to Table 2 for the recommended oil viscosity.

Engine Oil and Filter Change During normal engine operation, change the engine oil after every 100 hours of operation. Replace the engine oil filter after every 300 hours of operation. During break-in of a new or overhauled engine, change the engine oil after the first 20 hours of use, then after the next 30 hours of use. Change the engine oil at normal intervals thereafter. Refer to the Engine Oil section in this chapter for the recommended oil type. Refer to Table 2 for viscosity and Table 3 for crankcase oil capacity. Most installations do not leave enough space to permit the use of the oil pan drain plug.

For this reason, an oil drain suction pump is the most common device used to drain the crankcase oil. The pump has a long, flexible hose, which is inserted into the oil dipstick tube and fed into the crankcase. Several makes of pumps are available from marine supply dealers. Some are hand-operated, some are motorized and others are designed to be operated with an electric drill (Figure 4). Direct the used oil into a sealable container and prop- erly dispose of it. Engine Oil Level Check All engines will consume a certain amount of oil as a lu- bricating and cooling agent. The amount depends on en- gine use and engine condition.

During the engine break-in period, the engine consumes more oil while the piston rings seat in the cylinder bore. Engines with high hours of use may bum more oil due to worn engine components. Engines generally consume more oil at higher engine speeds. When to check engine oil is generally determined by the engine's oil consumption rate. If the engine has a high oil consumption rate, then check the oil level before each use or daily. If engine oil consumption is low,check the oil level weekly. The best procedure is to check the oil level before operating the engine. NOTE Never dispose of motor oil in the trash, on the ground, down a storm drain or over- board.

Many service stations accept used