Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

46 CHAPTER THREE motor oil and waste haulers provide curb- side used motor oil collection. Do not com- bine other fluids ~vith motor oil to be recycled. To locate a recycler, contact the American Petroleum Institute (API) at wwwre cycleoit.org. The oil filter is a disposable spin-on type. An oil filter wrench can be used to remove the filter, but do not use it to install the new filter. Overtightening the filter may cause it to leak. The installed angle of the engine affects oil lcvcl in the crankcase. To assure that the oil is drained and replaced properly, perform the following procedure with the boat at rest in the water. 1.

Start the engine and wann it to normal operating tem- perature under load, then shut it off. 2. Remove the dipstick and wipe it clean with a lint-free cloth or paper towel. 3. Insert the oil drain pump hose into the dipstick tube as far as it wiII go. 4. Insert the other pump hose into a sealable container large enough to hold the oil from the crankcase. Refer to T ab le 3 to determine the capacity of the engine crankcase. 5. Operate the pump until it has removed all of the oil possible from the crankcase. Remove the pump hose from the dipstick tube. 6. Place a drain pan or other suitable container under the filter (Fig ur e 5) to catch any oil spillage when the filter is removed. 7.

Unscrew the filter counterclockwise. Use the filter wrench if the filter is tight. NOTE Check the area under and around the oiljil - ter for leaks while the engine is running in Step /5. 8. Wipe the gasket surface on the engine block clean with a paper towel. IS. Start the engine and let it idle for five minutes, then shut off the engine. 9. Coat the neoprene gasket on the new filter with a thin coat of clean engine oii. 10. Screw the new filter onto the engine by hand until the gasket just touches the engine block. At this point, there will be a very slight resistance when turning the filter. 16. Wait approximately five minutes, then remove the dipstick.

Wipe the dipstick clean with a lint-free cloth or paper towel and reinsert it in the dipstick tube. Remove the dipstick a second time and check the oil level. Add oil, if necessary, to bring the level up to the full mark, but do net overfill. I I. Tighten the filter another 2/3 tum by hand. Using a filter wrench can lead to overtightening the filter. This can damage the filter or cause an oil leak. 12. Remove the oil filler cap or plug from the rocker arm cover. See Figure 2 (single cylinder models) or Fig ure 3 (mult icylinder models). Fuel System Serv ice 13. Reinstall the dipstick in the dipstick tube .

Diesel fuel injection systems require clean fuel that meets the fuel requirements specified by the engine manu- facturer. Due to the close tolerances required in the fuel injection system, diesel engines are particularly suscepti- ble to dirt or other contaminants in the fuel. Use only clean 14. Refer to Table 3 to determine the crankcase capacity of the engine. Pour the specified amount of oil into the rocker am cover opening and install the oil filler cap or plug. Wipe up any spills on the cover .