OPERATION, LUBRICATION, MAINTENANCE AND TUNE-UP 47 Air that enters the fuel system due to a damaged fuel line or loose connection may cause the engine to missfire. Bleed the fuel system as described in this chapter. Ai! bleed plug Fuelfilter Using clean fuel and maintaining the fuel system are extremely important when operating a diesel engine. Die- sel fuel, in addition to its obvious function as fuel, pro- vides lubrication for various components of the injection system. Due to close operating tolerances, dirty fuel can cause major damage to the fuel injection pump and injec- tors.
The engine is equipped with a fuel filter (Figure 6, typical) to remove dirt from the fuel before it enters the fuel injection pump. After every 50 hours of operation, or more frequently if necessary, remove and disassemble the fuel filter and clean the inside of the fuel bowl and filter element. The filter body contains a replaceable element. Replace the el- ement after every 250 hours of operation or more fre- quently if dirt clogs the element after fewer hours of operation. It is a good practice to replace the fuel filter ev- ery season or ifthe engine has not been operated for an ex- tended period.
O-ring 111--- Filter element Canister ~ Retaining ,'ng NOTE The boat may be equipped with additional fuel filters. Be sure to clean and maintain those filters according to the manufacturer S instructions. NOTE If the fuel filtering system is inadequate to properly protect the engine, consult with a marine dealership that has experience with diesel engines for fuel filter recommenda- tions. fuel and maintain the fuel filter and fuel system compo- nents to prevent a fuel system malfunction. WARNING Serious fire hazards always exist around dieselfuel. Do not allow any smoking in ar- eas where fuel is present.
Always have afire extinguisher, rated for fuel and electrical fires, on hand when refueling or servicing any part of the fuel system. Refer to Figure 7 when using the following procedure to clean the filter or replace the filter element: I. Position a receptacle under the filter to catch spilled fuel. 2. Unscrew the retaining ring and remove the canister and filter element. Note that the O-ring may remain on the filter body or on the canister. 3. Remove the element from the canister. If dirty or dam- aged, discard the element. 4. Clean the canister in clean diesel fuel. 5. Install the filter element in the canister. 6. Install a new O-ring on the canister. 7.
Install the canister on the filter body, then install the re- tainer ring and tighten it hand-tight. Fuel lines Periodically inspect all fuel lines for leakage and dam- age. Replace or tighten them as required. Do not overtighten a fitting to try to stop a leak; overtightening may damage the fitting threads or the fuel line sealing sur- faces.