Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

48 CHAPTER THREE 8. Loosen the air bleed plug (F igure 8) on top of the fuel filter body. 9. Make sure the fuel tank valve is open, then operate the primer lever on the fuel transfer pump (Figure 9). 10. Operate the lever while observing the fuel emitted around the bleed plug. Air will be emitted along with the fuel. Stop operating the lever when the fuel is free of air, then tighten the air bleed plug. Bleeding air from the fuel system Whenever air enters the fuel injection system, such as when the fuel tank runs dry, components arc replaced, or a fuel line is damaged or disconnected, bleed the air from the fuel system to prevent eng ine misfire.

Refer to Chap- ter Seven for the air bleeding procedure. 4. Clean the foam filter and mesh cone in soapy water. If the foam filter cannot be cleaned, discard it and install a new filter. Let the foam filter dry. 5. Reassemble and reinstall the filter by reversing the re- moval procedure. Air Filter An air filter (A, Figure 10, typical) removes airborne dirt and debris. Within the air filter canister is a reuseable polyurethane filter clement. Clean the filter element after every 250 hours of operation or more frequently if the en- gine operates in a dirty environment. Inspect the filter ele- men t before each o perat ing season to be sure it is clean and undamaged.

NOTE Be sure the intake tube (C, Figure 10) of the canister points slightly downward and not upward; otherwise. water can enter the tube and run into thejilter. Use the following procedure to remove and clean the filter clement: Drive B elt s Inspect all drive belts at regular intervals to make sure they arc in good condition and are properly tensioned. Re- place worn, frayed, cracked or glazed belts. The compo- nents to which they direct power arc essential to the safe and reliable operation of the boat. If correct adjustment is maintained on each belt, all will usually give the same ser- vice life.

For this reason and because of the cost involved in replacing an inner belt (requiring the removal of the I. Unsnap the filter canister retaining clip (B, Fig ure 10) and remove the canister and filter element. 2. Separate the filter clement from the canister (Fig ure 11). Note the mesh cone inside the foam filter. 3. Inspect the foam for holes, tears or other damage. Dis- car d the foam if damaged.