Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

OP ERATlO :-l. L UBRI C ATION . MAINTENANCE AND TUNE- UP 49 A 3 2. To adjust alternator drive bell tension, loosen the alter- nator retaining nuts (8 , Fil:ure 12), then reposition the al- ternator. Retighten the retaining bolts and recheck belt tension. Alternator drive belt adjU!ilmenl {models equipped .... ith fresh .... ater cooling) The alternator drive belt also drives the freshwater cool- ing pump on engi nes so equipped. outer belt), it is a good idea to replace all belts as a set.

The added expense is small compa red 10 the cost of replacing the belts individually, and replacing each belt reduces the possibility ofa breakdown on the water, which could cost far more in time and money. I. Check alternator drive belt tens ion by depressing the drive belt at the midway point on the belt (A, Figure 13). The belt should deflect approx imately 0.4 in (10 mm) with moderate finger pressure. 2. To adjust alterna tor drive belt tension, loosen the alter- nator retaining bolts (B, Figure 12), then reposition the al- ternator. Retighten the retaining bolts and recheck belt tension. Make sure the drive belts arc properly tensioned at all limes.

I flo ose, the belts will not drive the driven compo- nenrs at maxim um efficiency. The belts wil lalso wear rap- idly because of the increased friction caused by slippage. Bells that are too tight will be overstressed and prone to premature failure. An excessively light belt will also e ver- stress the water pump or alternator bearings. resulting in premature failure. Sea .... ater pump drive belt adjU'ifmenl (2G.U. 2G.U20. 3GM . 3GM30 . 3H. \f And 311.\ /35 mod els) I. Check seawater pump drive belt tension by depressing the drive belt at the midway point on the belt (A, Figur e Alternator drive bell udju.\lmelll (models equipped with seawater cooling) 14).

The belt should deflect approximately 0.24 in (6 mm) with moderate finger pressure. 2. To adjust seawater pump drive belt tension, loosen the screws (B, Figu re 14) that retain the water pump mount- ing plate. Reposition the plate to obtain the correct belt tension, then retighten the bolt and nut. Recheck belt ten- sron. 1. Check alternator drive bell tension by depressing the drive belt at the midway point on the belt (A. F igur e 11). The belt should deflect approximately 0.4 inch (10 mm) with moderate finger pressure.