Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

50 CHAPTER THREE Reed valve B Intake port Alternator drive belt replacement (all models) 1. Loosen the alternator retaining nuts (B, Figure 12). 2. Move the alternator inward sufficiently to allow re- moval of the belt from the pulleys and remove the belt. 3. Clean the pulley grooves so they are dry and free of rust or other corrosion. 4. Place the new belt in the pulley grooves. 5. Adjust belt tension as previously described. -t~---tIt-----IIt- Deflector Seawater pump drive belt replacement (2GM, 2GM20, 3GM, 3GM30, 3HM and 3HM35 models) 1. Remove the alternator drive belt as described in the previous section. 2. Loosen the screws that secure the seawater pump mounting plate (B, Figure 14).

3. Move the alternator inward sufficiently to allow re- moval of the belt from the pulleys and remove the belt. 4. Clean the pulley grooves so they are dry and free of rust or other corrosion. 5. Place the new belt in the pulley grooves. 6. Adjust belt tension as previously described. Drilled hole Mesh--_II!I'li:'~ Crankcase Breather The crankcase breather assembly vents crankcase pressure into the intake port or manifold. This produces a negative pressure in the crankcase. If the breather mal- functions, oil may be forced past the piston rings, oil seals and gaskets. Periodic maintenance is not normally required unless excessive oil gasses clog the crankcase breather.

This is usually indicated by blue exhaust smoke or oil in the in- take port or manifold. If the breather must be cleaned fre- quently, determine the cause, such as broken or stuck piston rings. Refer to Chapter Five or Six for service procedures for the crankcase breather. Refer to the following paragraphs for a description of the breather on specific models. On IGM and IGMIO models, a reed valve system lo- cated on the rocker arm cover controls crankcase gas movement. See Figure 15. The reed valve opens when the downward moving piston increases crankcase gas pres-