OPERATION, LUBRICATIO N, MAINTENANCE A"' D TUNE-UP 51 3 Sacrificial anode ~ ~ ~ ~ ~fr:: jj - sacrificial ~ anode gases. See Fig ure 17. A breather tube routes the crank- case gases to the intake manifold. Anticor ros ion :\Iai nten an ce The engines are equipped with sacrificial anodes that provide protection against galvanic corrosion. S acr ificial an ode s are relatively inexpensive and easily replaceable components that provide adequate corrosion protection in most situations where light-to-moderate corros ion condi- tions exist. Anod es arc made of a highly active zinc alloy. Check the condition of the anodes periodically and fre- quently.
Replace any anode that is corroded to 50 percent of its original size. Engine models IGM and IGMI D are equipped with a single sacrificial anode that is attached to a plate located on the cy linder block (f'i J=: ure 18). A threaded type sacnfi- cial an ode is used on 2GM, 2GM20. 3GM. 3GM30. 3HM and 3HM35 model engines. One anode is located in the cylinder head (Figure 19), and one anode is located in the cylin der bl ock on 2G M and 2G M20 model engines ( f' i g ~ sure. The reed valve closes when the piston moves up in the cylinder. Th is creates a negative pressure in the crank- case. which helps the piston rings seal against the cylin der bore.
A hole in the brea ther chamber routes oil back to the crankcase; however, excessive oil will pass through the connecting lube into the intake port. On 2GM. 2GM20, 3G~ and 3G ~30 models. the crankcase breather is located on the rocker a nn cover. A labyrinth system separates oil from the crankcase gas. See Ft gur e 16. A hole in the breat her chamber routes oil back into the engi ne. however. excessive oil will pass into the breather tube to the intake port or intake manifold. ur e 20). while two anodes are located in the cylinder block on 3GM . 3GM30. 3HM and 3HM35 model en- gmes. Proceed as follo ws to service the sacrificial anodes: On 3HM and 3 11 M35 models.
a mesh assembly on top of the rocker ann cover separates oil from the crankcase I GM and I GMI Omodels I. Drain the cooling system.