Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

52 C HA PT ER T HREE SACRIFICIAL ANODE ORIGINAL SIZES 1 GM AND 1GM10 MODELS T mm Din.) 20 (0.8 2. Unscrew the mounting plate (Figure 18) and remove the sacrificial anode ( F i ~ u r e 21). 3. Usc a wire brush and remove corrosion on the anode. Clean the mounting plate and mounting surface on the en- gine block. 4. Inspccr rhe anode and compare it with the dimensions ora new anode shown in Ftgure 22. Replace the anode if dimensions are less than 50 percent of original size. 5. Install a new gasket on the anode (Figure 23). ~ i+- ~ O mm (0.801n. )+ 2GM , 2GGM20 , 3GM , 3GM30 , 3HM AND 3HM35 MODELS ,VOTE Do not appl y any sealer to the anode mount- ing plate or 10 the engine block.

Sealer or corroded mating surfaces will prevent good electrical CU IIlac t, which is necessary for optimum anode protection. - t 20m m (0.80 In.) 6. Reassemble and reinstall the sacrificial ano de in the engine. ~ - .- 3 0mm J (2.00 In.) '- , 2GM, 2G .U20. 3GM, 3GMJ O, 3 HJ I am i 3 HM 35 models I. Drain the cooling system. 2. Unscrew the sacrificial anodes in the cylinder head ( Fig ure 19) and cylinder block (Fi l:, ure 20). 3. Use a wire brush to remove corrosion from the anode. Clean the threads on the anode and in the engine. which is neces saryfor optimum anode pro- tection. 4. Inspect the anode and compare it with the dimension. s ofa new anode sho ..... -n in Fi2ure 22.

Replace the anode if dimensions are less than 50 percent of original size . 5. Install a new gasket on the anode (Figure 23). 6. Reas semble and reinstall the sacrificial anode in the engine. COO I.I ' G SYST D ·I NOTE Do not apply any seater to threads on the anode or in the engine. Sealer or corroded threads will prevent good electrical contact. Refer to Chapter Eight for a description of the two types of cooling systems that are used on the Yanmar marine diesel eng ines covered in this manual. A freshwater