OPERATION, LUBRICATION, MAINTENANCE AND TUNE-UP 53 ANODE MOUNTINGS 1GM AND 1GM10 MODELS Anode F-tRQ ~hl ..---F' .... Gasket ~ Lockwasher ~Bolt Mounting plug Mounting plug Gas~~ ~ GaSket~~ Anode ~~GaSket Anode~ CYLINDER HEAD CYLINDER BLOCK 2GM, 2GM20, 3GM, 3GM30, 3HM AND 3HM35 MODELS (closed) cooling system requires additional maintenance due to the freshwater portion of the system, which in- cludes a freshwater pump and may include an antifreeze mixture. may be used for most engines, but modification of the pro- cedure may be necessary for some installations. 1. Detach the inlet hose from the water pump. 2. Connect a hose from a water tap to the inlet of the wa- terpump.
Seawater (Standard) Cooling Systems 3. Open the water tap. Flushing the system 4. With the transmission in neutral, start the engine and run at normal idle until the engine reaches normal operat- ing temperature. Flushing procedures may differ depending upon engine installation and the location of the water pump. Regard- less of pump location, cooling water must always circu- late through the water pump whenever the engine is running to prevent damage to the pump impeller. On mod- els equipped with a closed cooling system, both pumps must be supplied with cooling water.
The following procedure provides steps to flush the cooling system of engines equipped with a seawater cool- ing system as well as the seawater portion on engines equipped with a closed cooling system. This procedure 5. Observe the water being flushed from the cooling sys- tem. When the flow is clear, shut the engine off, then shut off the water tap. 6. Reconnect the inlet hose to the water pump. NOTE Refer to Chapter Eight toflush and refill the freshwater portion of a closed cooling sys- tem or to service the heat exchanger.